Ebco Pvt. Ltd. - Computer Stationery Products

1. Fit the retainer plate under the table top leaving 15mm from the front. Fit the Stopper Bush at the rear end. (Ref. Fig.1) Use pan head wood screws provided.
2. Slide the Arm assembly into the retainer plate.(Ref. Fig. 2)
3. Screw the plastic front stopper onto the front end of the retainer plate.(Ref. Fig.3)

• Fit slides parallel and at equal height.

• Fit slides parallel and at equal height

1.Minimum horizontal gap required 600 mm.

2.Drill as per drilling diagram Fig.1.

3.Assemble Height adjustment brackets on toslides using M4 screw provided as in Fig.2.

4.Height adjustment bracket should beadjusted for desired height.

5.Screw the mounting bracket onto the table as shownin Fig. 3.

1. Minimum horizontal gap required is 550mm.
2. Drill as per drilling diagram as in Fig. 1.
3. Assemble height adjustment brackets on to the slides using M4 screws provided as in Fig. 2.
4. Height adjustment bracket should be adjusted for desired height.
5. Screw the mounting bracket 85mm distance from the edge of the table and to other end 255mm & 355mm respectively for 350mm & 400mm slides (Refer Fig. 3)

1. Assemble Height adjustment brackets on to slides using M4 screw provided as in Fig.1
2. Drill as per drilling diagram Fig.2
3. Height adjustment bracket should be adjusted for desired height.
4. Screw the key board onto the table. Table should have minimum horizontal gap of 700mm.
5. Slide the Keyboard Tray out till it automatically latches.
6. To remove tray lift latches provided on each sides and pull as per Fig.3

1. Minimum horizontal gap required 600 mm.
2. Screw the mounting brackets at 85 mm distance from the front edge of the table and to other 255 mm. (Ref. Fig.1)
3. Drill as per drilling diagram as in Fig. 2.
4. Assemble height adjustment brackets on to the slides using M4 screws provided, as in Fig. 3
5. Height adjustment bracket should be adjusted for desired height.