arab chemical consulting center

Cairo, Egypt

The film holders, available in two versions Mark 1 and Mark 2, were developed by the National Radiological Protection Board (NRPB), now Health Protection Agency (HPA), and are produced and marketed by Loxford Equipment Company Limited.The design of the two types of holder is based on a six filter system which satisfies the requirement that the filters are large enough to minimise edge effects, as well as leakage, and that there are a sufficient number of filters to enable a detailed and accurate dose assessment to be made.The Mark 1 and Mark 2 holders have the same filters, the main difference being in the fastening arrangement. Both are intended for use with Kodak Type 2 Monitoring Film or a similar product and both are available in blue or red.2. An open window which allows all incident radiation that can penetrate the film wrapping to interact with the film. This window allows for the film serial number to be displayed.3. A thin plastic filter which attenuates beta radiation but passes all other radiations.4. A thick plastic filter which passes all but the lowest energy photon radiation and absorbs all but the highest energy beta radiation.5. A dural filter which progressively absorbs photon radiation at energies below 65 KeV as well as beta radiation.6. A tin/lead filter of a thickness which allows energy independent dose response of the film over the photon energy range 75 KeV to 2MeV.7. A cadmium/lead filter where the capture of neutrons by cadmium produces gamma rays which blacken the film thus enabling assessment of exposure to neutrons.In addition a strip of indium foil may be housed in a recess in the badge. This foil becomes radioactive after exposure to neutrons and can be used to identify exposed personnel in the event of a criticality accident.