G C Chandra & Co. - Beds

1. Hospital Fowler Bed with facility to raise back section, operated by crank mechanism, provided at foot end of the bed.

1. Fixed height Bed
2. MS Sheet Top
3. Legs with PVC rubber feet
4. Pre treated epoxy powder coated
5. provision for Mosquito net poles



Size:

• 1950mm L X 910mm W X 600mm H

1. Hospital Fowler Bed with facility to raise back and upper leg sections, operated by electric actuators. Cabled remote switch for operation. ABS 4 piece butterfly type Side Railings
2. Four section top made of 1 mm thick CRCA sheet with perforations at regular intervals. Provision for IV poles at four locations. Mounted on four 125 mm dia swivel castors, two with brakes. Polymer moulded head and foot boards.
3. Thoroughly pre treated and epoxy powder coated.




Size:

• 2100 mm L x 900 mm W x 600 mm H

Size:

• 2100 mm L x 900 mm W x 600 mm H

1. Main bed frame made of 50 x 25 x 18 gauge Mild Steel rectangular tubes with two cross supports . Top made of 1 mm thick CRCA sheet with perforations at regular intervals. Head and leg bows of equal height made of 31 mm dia MS tube with cross supports. Vertical bars should be of intervals not more than 100 mm. A pair of full length safety side rails of 18 height.
2. Pre treated and epoxy powder coated.


Size:

• Overall approximate dimension- 1370mm L x 750mm W x 600 mm H.

1. Four actuator ICU Bed with adjustable backrest, knee rest, height and trendlenburg / Reverse Trendlenburg positions obtained by hand held cabled remote switch . Main bed frame made of 60 mm x 30 mm x 16 gauge Mils Steel rectangular tube. 1.2 mm thick CRCA Perforated Sheet Top.
2. Polymer Moulded Removable Head & Foot Board. Collapsible type/ four part polymer moulded safety side railing. Four locations for IV pole. Mounted on 125 mm dia polymer moulded anti rust type swivel castors, two with brakes. Urine bag holder, telescopic IV pole.
3. Thoroughly pre treated and epoxy powder coated.


Size:

• 2150 to 2160 mm L x 1010 to 1020 mm W
• Bed Frame approx dimension : 2060 to 2070 mm L x 900 to 910 mm W
• Minimum Height 530mm approx (without Mattress)
• Maximum Height 740 mm approx(without mattress)

1. Framework made of strong steel tubes
2. Canvas Velcro Top
3. 9" canvas centre hole & bowl for canvas centre hole
4. Powder Coated Finish
5. Legs are foldable
Size:

• 78" L X 35" W X 24" H

1. Main bed frame made of 50 x 25 x 18 gauge Mild Steel rectangular tubes with two cross supports .
2. Top made of 1 mm thick CRCA sheet with perforations at regular intervals. Head and leg bows of equal height made of 31 mm dia Mild Steel tube with cross supports. Vertical bars should be of intervals not more than 100 mm. A pair of full length safety side rails of 18 height.
3. Pre treated and epoxy powder coated.




Size:

• Overall approximate dimension- 1370mm L x 750mm W x 600 mm H.

Description:
1. Framework made of Rectangular/Square MS Tube
2. 5 cm foam padded top covered with rexene
3. Leg Fitted with PVC Stumps
4. Powder coated finish

Size:

• 180L X 60W X 46H cm