Our Products
Trans-receiver is simply a combination of both optical transmitter and optical receiver. It can achieve RF output of desired level of optical signal(+2 -8dBm). Same time we can get optical power of desired level(9 dBm or 10 dBm). It uses two adaptors, one as a optical in and one as a optical out. Aluminum alloy body is used in outdoors trans-receivers. Very perfect and accurate SMPS is used to operate this kind of trans-receivers.
Cable TV system is directly link with public. It is necessary to reach the RF signal 24 hours consumer end. Therefore , it is necessary to keep our whole system (control-room, amplifiers, node etc.) to provide initial power supply every time through same co-axial cable wire to operate active power devices is called Power Pass System. Power Supply and Radio frequency are two differencing. However for mixing up these two signals always use power inserter. Without using power inserter may cause the poor quality transmission.
Cables for high speed data transmission digital & analog voice and video signal of lens. Operates at band width up to 100 MHz Cat 5e and 250 MHz Cat 6e cables are used meeting the requirement EIA/TIA 568B.2 specification .
Coaxial cable or coax is a type of cable that has an inner conductor surrounded by a tubular insulating layer, surrounded by a tubular conducting shield. Many coaxial cables also have an insulating outer sheath or jacket. The term coaxial comes from the inner conductor and the outer shield sharing a geometric axis. Coaxial cable differs from other shielded cable used for carrying lower-frequency signals, such as audio signals, in that the dimensions of the cable are controlled to give a precise, constant conductor spacing, which is needed for it to function efficiently as a radio frequency transmission line.
An inverter provides power backup for mains-based appliances in the event of a power failure. Most of the inverters available in the market have complicated circuit design and are not very economical. Some of them produce a square-wave output, which is undesirable for inductive loads. Here we present a simple inverter circuit that produces 50Hz quasi sine-wave output using a single IC CD4047 and some discrete components, which makes it a very cost-effective solution.
cctv camera accessories estimation of your venture by giving establishment and support administrations to high accuracy cameras and reconnaissance framework.Each of these frameworks accompanies a large group of components that would precisely live up to your desires and present to you an entire fulfillment