GST : 06AASPY1638C2ZE
4.0/5
Our Products
Our product range contains a wide range of Flame Arrestors, End of Line Flame Arrestor and in Line Flame Arrestor
End-of-line deagration flame arrester provides protection against atmospheric deagrations. The device is typically installed on vent lines of small vessels and plant equipment which is not pressurized. For safe application, it is important that an endurance burning situation can be excluded, so typically it is installed on vents lines which discharge vapor for a short time period only. The device prevents flame transmission from atmospheric deagration into the vessel or plant.
Special Features and Advantages
The compact design of the in-line deflagration flame arrester makes it the state of the art technology for installation in pipes. The devices are installed with minimal distance to the burner to prevent flash-back into the fuel feed lines. When installing the deflagration flame arrester, make sure that the distance between potential ignition sources and the location of the installed device, does not exceed the L/D ratio (pipe length/pipe diameter), for which the device was approved. As per EN ISO 16852 the L/D ratio is limited to (L/D) max ≤ 50 for deflagration flame arresters of explosion groups IIA and IIB3 (NEC groups D and C (MESG ≥ 0.65 mm)) and to (L/D)max ≤ 30 for explosion group IIC (NEC group B).
Ajay Singh Yadav (GANWAL ENGINEERING)
OII/C-62, IInd Floor, Palam Vyapaar Kendra, Palam Vihar, Gurugram, Haryana - 122017
Share us via
