Girish Ego Controls

Kalbadevi, Mumbai, Maharashtra

Panel Heater Box Type (Best Switchgear Enclosure Electric Panel Space Heater)

Box Types Space Heaters are ideal for prevention of condensation, corrosion. Leakage currents in L.T. & H.T. Switchgear panel boards / electronic instruments & panels etc.

Working Principle and Features:

The specially developed design incorporates a stainless steel sheathed cartridge heating element in perforated sheet metal enclosure. A black powder coated finish ensures rapid heat dissipation.

A 2 x 2.5 mm porcelain terminal block is provided for electrical connection

Mounting Holes are provided at one side

Each heater is tested for following specific tests. 1) High Voltage Test At 2Kv/1Min 2) Insulation Resistance > 10 Mega Ohms.3) Power Rating within 5%

Intended Use:

Prevention of condensation, corrosion, Leakage currents in L.T. & H.T. Switchgear panel boards / electronic instruments & panels etc.

Installation:

Two Holes of 7mm are provided for mounting on one side of the heater. Installation can be done in vertical or horizontal position although horizontal mounting is preferred. Distance from surface of panel should be at least 10 mm. and distance from plastic parts should be at least 50 mm.

Also available in complete Aluminium with Aluminium Fixing cover / Bracket

Additional Information:

Packaging Details: Box Packing

Enclosure Heater, PTC Panel Heater (best Switchgear Enclosure Electric Panel Space Heater)

These heaters are used in enclosures where damage from condensation must be prevented, orwhere the temperature may not fall below a minimum value. The aluminium profile heater bodydesign has a chimney effect and distributes the heat evenly. The pressure clamp connectors save time and simplify installation.

Panel Heater With Built In Thermostats "Combi Model"

PRODUCT DESCRIPTION: ‘Saiego’ Combi Space Heaters with built-in capillary Thermostat are ideal for prevention of condensation, corrosion & Leakage currents in L.T. & H.T. Switchgear panel boards / electronic instruments & panels etc. 

PRINCIPLE & FEATURES: In this, a long life and  sturdy extruded aluminium sheathed, mica insulated heater and an accurate capillary thermostat are place in a Rust resistant steel perforated body.  A 2 x 2.5 sqr. mm porcelain terminal block is provided for electrical connection. 

INTENDED USE: Prevention of condensation, corrosion & Leakage currents in L.T. & H.T. Switchgear panel boards, enclosures, switch boards,   & electronic instruments etc.

INSTALLATION: Four side slot holes for fixing tabs  are provided  for fitting the heater in the panel. Installation can be done in vertical or horizontal position although vertical mounting is preferred. Distance from surface of panel should be at least 10mm and distance from plastic parts should be at least 50mm. Connection wire must be on the side or below to avoid warming up of the wire

Additional Information:

Packaging Details: BOX PACKING