HINDUSTAN BIJLEE

Margao, Goa

Voltage fluctuations can cause hardware failure, mal-operation, loss or error in processed data. The transient voltage produced by load changes can also be injurious to sensitive circuit components.
Beta Servo control stabilizer is designed to give stabilized output voltage within +/- 3% of the total present output voltage in a few milliseconds.
There are single and three phase servo stabilizers available.


Salient Features

1. High efficiency.
2. Reliable IC control version.
3. Fast response.
4. Wide input range.
5. Transient & Spike free output.
6. No over/under shooting or hunting.
7. No waveform distortion.
8. No effect of power factor and frequency variation.
9. Maintenance-free A.C. Synchronous motor of long life is used.


Technical Specifications

a) Input Voltage: Single Phase - 160 to 270 V
b) Nominal Output: Single Phase - 230V +/- 3%
c) Load on Power: None
d) Output Wave Form Distortion: None
e) Control Circuit: New improved designed ICS & TRAICS etc.
f) High/Low Voltage cutout with time delay
g) Efficiency: Better than 95%
h) Correction Rate: 30 to 40 volts/sec.
i) Motor: 230 VAC Synchronous gearless reversible servo motor with 3.5 kg. cm.
j) Torque at 60 RPM
k) Effect of load on Power Factor - none


Applications


Computers

Medical instruments

Fax and Teleprinter

EPABX & Communication equipments

Industrial process control

Audio/Video systems

Lighting systems

Designed by HINDUSTAN BIJLEE, the Line Voltage Corrector is a manual voltage stabilizer for boosting voltage from 120v onwards.
The Line Voltage Corrector has:
a)Boost/Normal Switch: For incoming voltage of 160 V or below, select switch to Boost Mode.
When incoming voltage is above 160V, select switch Normal Mode.
b)Stabilizer/Bypass Mode Switch: When stabilizer is required to work, select the 2 nos, 2 Way SwitchON(MarkedStabilizer).
When both these switches are keptOFF, Stabilizer will bypass. (MarkedBypass).


Salient Features

1. High voltage cutout
2. Stabilizer bypass
3. Boost/Normal selection switch
4. Step by step increasing/decreasing selector
5. Input/Output voltage monitoring


Technical Specifications

a) Input: 120 - 300 volts.
b) Output: 200 - 240 volts.
c) Capacity: 5 KVA.
d) Main on / Approach indicator.
e) 5A, two-way switch IN/Out monitoring. (Voltmeter & Main on LED.)
f) 15A, two-way switch Boost/Normal switch.
g) 15A, two-way, two nos. switch mode - Stabilizer/By pass selector.
h) 15A Output socket.
i) 8 way rotary switch for fine control of increases/decreases in voltage settings.


Applications


Music system

Lighting load