Info Systems

Used for intelligently charging 24V/30A batteries either using solar energy or DC input voltage In addition to charging battery, an output is also provided to connect to a load Capable of pushing charge even in very low temperature areas Pulse Width Modulation is used for optimum charging

Repackaged Monitors, CPUs, Keyboards and Mice for stacking in racks and using in rugged and rough terrain areas Cost effective solution when compared to existing industrial PCs used in rough terrains

Two channel micro controller based vehicle detector Implemented in vehicle actuated traffic lights Loop isolation transformer provides protection against lightning and transient damage

Used to convert 24V DC to 12V DC, 3A and 24V DC to settable output voltage in range of 12V to 18V, 3A Input voltage can vary from 18V to 36V Supplies current up to 3A

Used to generate DC Voltage & Current to charge the 12V Ni-Cd Battery used in HF Radio Hand cranking at 80 rpm generates the required DC Voltage and Current Housed in an Aluminum die cast enclosure Supports enable easy mounting and cranking Carrying case is provided for easily transporting the generator with accessories

Used for removing chips produced by gears, ball-bearings, transmission lines etc. in the helicopters by using electrical power pulses automatically Size and number of the chips burnt and corresponding date and time information are stored in CBU’s memory throughout the flight and also displayed in the cockpit Data can be downloaded to PC for analysis and maintenance, and configuration of CBU parameters can be done using PC Transmits processed parameters continuously during the flight for display in the cockpit

Universal Checkout System A computer based electronic scanning, measurement and analysis display system for cables and electronic modules Housed in 19” rack system and on wheels Used to check continuity/discontinuity, measurement of ohmic resistor, insulation resistance, break down strength, diode, cable assemblies and relay units