Our Products
Our product range contains a wide range of Center Hole Load Cell, Base Load Cell and Roof Support Load Cells
These are rugged and compact sensors used to measure loads in tiebacks, rockbolts, struts or tunnel supports. These are designed to meet the demands of the severe and adverse environmental conditions usually associated with construction or mining activities. To monitor tensile load, the load cell assembly has an annular configuration to enable the passage of anchor through it. To monitor compressive load, the load cell is provided with integral solid centre platens mounted on the end faces of the load sensing element. The load cells have three or six vibrating wire sensors to nullify the effect of eccentricity and an average of the readings of all gauges is equal to the applied load.
Typical Applications
These are used at the base and crown of steel reinforcement ribs in tunnels and under ground structures.
Typical Applications
These are vibrating wire load cells provided with a swivelling top plate and fixed bottom plate. Number of vibrating wire sensors is generally three. These are used in mines for monitoring load during and after excavation. A beam is provided between the swivel top of the load cell and the roof. The load cell is positioned at the floor along with the convergence meter. Provision of gas discharge tube protects the sensor against surge and lightning.
Typical Applications
Ms Saba Qamar & Mr. B.M Gujral (Innovative Geotechnical Instrumentation)
B 970 Sector- A Mahangar Lucknow-226006 U.P., Mahanagar, Uttar Pradesh, India
Share us via
Write a Review
