A two component paste, based on a aluminum powder filled epoxy system. The non-rusting, non magnetic dependable inert putty extensively used for fairing, repair or patching of aluminum castings and equipment where aluminum finish is desired. Features of Aluminum PuttyFast, cost effective and durableHigh compressive strength and extreme chemical resistanceGood resistance to corrosion and abrasionEfficient alternate method of repair where welding or brazing would be undesirable or impossibleCan Repair Intricate shape or formsthin sections, difficult to weld metalsNo equipmentPower supply neededUnlimited cycle of repairsLess Labor costs - Avoid assemblydisassembly, Pre MachiningPost MachiningResistant to chemicals and most acids, bases, solvents, and alkalisIt can be easily Can be machined, drilled, tapped or paintedSuperior adhesion forms a solid bond to steel, cast iron, Stainless steel, concrete, and clean and abraded bronze, copper, and aluminum.Eliminates costly wear part inventoryNo shrinkage, expansion or distortionExcellent electrical insulation characteristicsCan do repairs at In-situ repair, In-Plant, Workshops, Remote areasNo VOC'sRoutine Maintenance and Unexpected MaintenanceRepair cost at fraction of replacement costWhere to Use?Patch aluminum castings; make jigs, dies, and holding fixturesAluminum castings, machinery, and equipment widelyUsed in HVAC applicationsRepairing aluminum castingsMaking aluminum diesFilling Blow HolesNon Corroding , Anti magnetic parts