Our Products
J. D. Controls manufacturing Forged Steel Check Valves have body guided piston assuring accurate return to seat ring to achieve leak tightness. This Check Valves are suitable for only Horizontal Line. The standard range of J. D. Forged Steel Lift Check Valves (Non Return Valve) covers sizes of up to 2 (DN50).
Valve Design : BS 5352
Pressure Testing : BS 5146
Face To Face : ANSI B 16.10
Butt Weld End : ANSI B 16.25
Socket Weld End : ANSI B 16.11
Screwed End : ANSI B 1.20.1(BSP/NPT)
Y-Type Strainersare typically used in application where the amount of solids to be removed is small, and where frequent clean out is not required.They are most commonly used in pressurized lines, gas or liquid, but can also be used in suction or vacuum conditions.
Y Strainer mechanically removing solids from flowing liquids, Air, Steam or gases by means of a perforated or wire mesh straining element.
Y-Strainer has the advantage of being able to be installed in either a horizontal or vertical position.
The screening element or leg must be on the downside of the strainer body so that entrapped solids can be properly collected and held for disposal.
A blow down plug on the drain port will allow clean-out without removal of the screen, and without interrupting the process flow.
Cast Iron to ASTM A 126 Class B
IS 210 GR. FG 200 / 220 / 260
Cast Carbon Steel to ASTM A 216 GR. WCB
Stainless Steel to ASTM A 351 GR. CF 8 / 8M / 3 / 3M
Carbon Steel to IS 2062 (Fabricated Type)
S.S. 304 / 316 / 304L / 316L (Fabricated Type)
Others on request
S.S. 304
S.S. 316
S.S. 304L
S.S. 316L
Brass
Design Std. : Mfg. Standard
Pressure Testing : Mfg. Standard
Face To Face : Mfg. Standard
Flange Drilling : ANSI B 16.5 / BS 10 Table / DIN / IS 6392
Pressure Rating : 125#, 150#
Size Range : 40mm (1) To 300mm (12)