Belts #2157315

We are offering timing belts. Make less noise compare to chain belts and gear belts and has high transmission capacity and efficiency. Timing belt is widely used for wood processing, mining, packing pipeline, weaving and many other machines. This belt doesn't require lubrication hence its maintenance free and able to deal with storm stress. Replacement of timing belts is time and cost saving than the alternative.

We are offering wedge belts & fhp/ m fraction. wedge belts have been the result of continuous thrust by the manufacturers and the users on higher power transmissions with reduction in space requirements. Wedge belts can transmit high power to extent of 1.5 to 2 times the classical belts with same top width this has been achieved by the dimensional changes, part from better cord constructions used and the optimum placing of the cord line which provides the best support to the cord while in motion. For efficient performance of wedge drives it is essential that the proper tension be maintained in the drives, failure to maintain the same will render the purpose of wedge belts ineffctive.

We are offering cogged belts. Suitable for all industrial applications, particularly where small or sub-minimal sheave diameters are required. features : 1. Tooth notches constructed onto the belt during manufacturing, make this belt well suited for drives with smaller diameter sheaves. 2. Belt edge is machined for even sheave groove contact resulting in less slip and wear. 3. Flexible cords are strongly bonded to the body of the belt resulting in equal load distribution and the absorption of bending stress without cord deterioration.

We are offering flat belts (canvas & conveyor). polydrive range of flat belts and conveyor belts covers a wide spectrum of types and applications. The following programme is a pointer towards the reach and production capabilities of polydrive.

We are offering link belts. the full depth of a v-section t-link belt is made up from 3 overlapping sections. the belt is joined or broken by simply rotating the t-headed pins until they line up with the slots cut in a each link. although the pins go right through each link there is always clearance for them in the bottom of the v pulleycommonly known as "link belts", which is a type of v-belt (it cannot be used on flat-belt drives), is widely used in industrial and marine applications. Although more expensive than ordinary v-belts it does have some important advantages.

We are offering banded belts. Banded belts are made up from classical, wedge or narrow belts with strong tie band over them. Each band may contain the required number of belts. Maximum up to 5 belts in one tie, depending upon the drive conditions, are recommended.