Joy D-Zign Engineers Pvt. Ltd.

Mundka, Delhi

Book Spine Pre-Gluer equipped with Hot Air IR Dryer, is the most economical system for preparation of Book-Blocks suitable for Soft or Hard Case Binding by pre-gluing and drying of section-sewn, pre-smashed and nipped signatures. The process ensures that the Book-Blocks maintain its rectangular shape, which is free from extreme gradients in the folded sewn area.
The section - sewn signatures / Book-blocks are held under set pressure with spine resting on the flat surface to ensure rightangle reference of the spine in relation to the height of the book.
The books upto a maximum pile size of 710mm can be processed at a time with pile under hydraulic pressure ranging from 1000- 1500kgs. The pile is hydraulically raised for turning the same to 180 with Spine-section exposed. Apply Glue with the help of a brush or sponge, a very thin layer of Glue/Adhesive (preferably flexible, non-swelling Synthetic such as polyvinyl or Animal/Jelly Glue etc. is recommended).

Ensure that the amount of Glue applied to the Spine should be just adequate to sufficiently seal the adjoining signatures. The Dryer Unit equipped with Quartz IR Heaters and High Speed fans is brought over the Book Spine Area by sliding the Unit towards operating side. The Adhesive is dried within 2-3 minutes. The Dryer Unit is pushed back to its reset position on completion of the set-time.

Book Spine Pre-Gluer Press is a neat cuboid of a machine sturdily built for processing Book-blocks economically with space / power saving and simple to operate for consistent quality.

Hydraulic Book Press TBP-II with two independent stations with fixed Pile Height upto 400mm. The printed title can be pasted on open book or board to board size up to 810x525mm with single Platen & day-light area upto 400mm.
The press can be used either in Manual or Auto-Mode with each station alternatively or together, resetting to loading position after pre-set time. The option to set time on a Digital Timer in Seconds (from 001 to 999).

The option available for use are : Independent control through separate switch for left and right hand side Platens through SELECTOR position No.1.
By selecting the 2nd position, the stations (platens) will operate in tandem to a pre-set duration in Auto-mode.
In SELECTOR position 1 & 2 both the Platens will move up simultaneously with combined force of 12000 kgs. Single Platen supplied for pressing Books, Account Ledgers, Book cases & Boards etc. of large formats.
Hydraulic system is based on 2 HP Power Pack and pressing force adjustable upto 6000 kgs on each station.
Conveniently located Control Panel. Castors are provided for maximum space utilisation.