My ExportersIndia

For Buyer

For Seller

For Help

Automobile Repair Tools & Equipment

Our product range contains a wide range of Tire Wash Equipment, Conveyor Car Wash Equipment, Automatic Advanced Bike Wash Equipment, Train Wash Equipment and Mining Truck Wash Equipment

Tire Wash Equipment

  • Country of Origin 415 VAC / 208 VAC
  • Phase 3 Phase
  • Frequency 50Hz / 60 Hz
  • Generator Can also run on Backup Generator System
  • Connected Load 17hp /12.7 kW

This configuration with KKE TW610 is a Portable Tire Wash configuration. It has a single segment of 4m length which is a suitable distance that can be cover one full rotation of the truck. The water jets from bottom and sides loosen the dirt and wash the tires of the Truck. This Bay is made of Galvanised Steel to ensure the long life.

The system has water collection system to transfer the collected water to a nearby collection tank. On both entry and exit of washing bay, zinc protected Ramps which are fixed in the concrete by Anchor bolts. The structure has a slope of 1:10 ratio. An Entry & Exit ramps are skid proof made with heavy galvanised steel sections.

A steel Collection tank of capacity 1000 Liters / 265 gallons(US), is provided to collect the water from the Tyre Wash Bay. A submersible pump is used to pump the water from this tank to the above ground tank. We have seen our customers washing up to 30 trucks per hour in such Tyre wash configuration. 20kl Tank is preferred for lightweight dirt like coal, etc.

The Settling tank is basically used for collection of water, where slit is removed by Backhoe. The settling tanks have three chambers and the pumps provided in the last chamber of the tank.

Standard Features
  • Tire Tread Squeezing structure design

  • High Volume Discharge system

  • Control System - Timer/Relay Based

  • System with On Delay activation

  • Hot Dip Galvanised Structure

Structure Width 3990 mm
Inside Tire Width    900 mm
Outside Tire Width 3,000 mm
Structure Length 10,000 mm
Maximum Axle Load 25,000 kg
Bay Dimensions  
Length 4,000 mm
Width 3,200 mm
Electricity  
Voltage 415 VAC / 208 VAC
Phase 3 Phase
Frequency 50Hz / 60 Hz
Generator Can also run on Backup Generator System
Connected Load 17hp /12.7 kW
View Complete Details

Conveyor Car Wash Equipment

12m Conveyor to wash approximately 20 - 30 cars per hour. This is a suggestive configuration. You can configure KKE Gamma Conveyor Car Wash Equipment as per your specific requirements. You can add or remove systems to cater to your local requirements.
Any requirement of approximately 10 cars per hour or more during the peak hours should consider a conveyorised car wash option. The KKE Gamma series has a robust conveyor and is hot dip galvanised for long life.
A typical 12 m configuration consists of the following :
Gamma Conveyor 20 35 cars per hour ( 12 + 1 m )

  • KKE101788 : Correlator
  • KKE101783 : Gamma Driving Unit 12m Conveyor
  • KKE101784 : Gamma Intermediate Units x 2
  • KKE101785 : Gamma Driven Unit
  • KKE101782 : Gamma Exit Side Collision Protection System
  • KKE101809 : Gamma Dual (Water + Foam) Spray Arch
  • KKE101769 : Gamma Skirt Brushes PE Bristles
  • KKE101770 : Gamma Vertical Wrap Around Brushes PE Bristles
  • KKE101779 : Gamma Top Roof Brush PE Bristles
  • KKE101814 : Gamma Rain Water Rinse Arch
  • KKE101775 : Gamma Silicon Wax Spray Arch
  • KKE101774 : Gamma 30 hp Blower Arch
  • KKE101781 : Gamma Control System
  • KKE102571 : Display Panel
  • KKE102380 : Tire Brush

KKE102572 : Under Chassis Wash 7.5 hp Can also be added if required.

The conveyor equipment is easy to operate and easy maintain.

Features
  • High Throughput
  • Roller on Demand Conveyor
  • Modular
  • Maintenance Free Correlator, UHMWPE Rollers
  • Exit Side Collision Prevention System
View Complete Details
Tell Us What are you looking for? Will call you back

Contact Us