Our Products
Leading Manufacturer, Supplier & Retailer of AUTOMATIC THERMIC FLUID HEATER, Furnace Burner and Burners.
i - Type Vertical/Horizontal, 3 pass, Coil Type Thermic Fluid Heater
ii - Capacity 50000 kcal/hr to 2500000 kcal/hr and above
iii - Temperature -Up to 300C and above
iv - Fuel -Gas / Diesel/Heavy Oil/ Dual Fuel
v - Thermal Efficiency -88% + 1% based on N.C.V. of Fuels
vi - Heat Recovery Unit Economiser (Optional)
vi - Air Preheater -In-built
OPERATIONi -Fully automatic operation with BURNER ON-OFF modulation for units up to 40 Lac kcal/hr and HIGH-LOW ON-OFF modulation for higher capacity units keeping FUEL CONSUMPTION in proportion with heat demand in the plant
ii -The Burner is pressure atomizing type and is centrally located at the top of the unit
iii -Burner is self igniting and maintains CLEAN and SMOKELESS COMBUSTION all throughout the operation
iv -Preheated combustion Air gives highest Combustion efficiency maintaining high CO2 % and Low Smoke Index
v -Hot Oil circulation pump is of centrifugal type maintaining the circulation of Hot Thermic Fluid through heating coil
vi -A Digital Temperature Controller senses the heat demand in the plant and controls the Burner ON-OFF/HIGH-LOW modulation maintaining minimum fuel consumption
vii -In case of any abnormal operating condition the SAFETIES provided stop the unit and put the same to SAFETY LOCKOUT CONDITION by giving AUDIBLE ALARM and VISUAL INDICATION
SAFETY FEATURESi -Flame failure device
ii -Thermic Fluid low flow tripping
iii -Overriding temperature tripping
iv -Blow down valve
v -Single phasing prevention cum over load for control circuit
vi -Miniature Circuit Breaker for control circuit
vii -Thermic Fluid level switch on expansion tank (optional)
viii -High stack temperature Annunciation/Alarm (optional)
ix -Fail Safe Instrumentation
x -Control circuit logic ensures Heater going to lock out safety in case of any abnormality in operating condition as well as monitoring instrument failure
Lafil industrial burners are pressure jet spill return fully automatic with stepless modulation & operate on oil, gas & dual fuels.
They have been designed & manufactured to high standards in order to meet the widest demands. The burners can be used on a wide range of equipment like boilers, hot oil heaters, hot air generators & furnace. High turndown ratios can be achieved without deterioration in combustion quality. Operation can be totally automatic and dual fuel burners can also be supplied for combined fuel burning. Lafil burners are designed for low excess & are totally compatible with on line oxygen trimming systems which regulate excess air thus ensuring good combustion at all loads. Lafil also supply oxygen trimming systems for all suppliers. Custom made burners for fuels like blast furnace gas & other lean gases can be supplied on request. Proper selection of burner is based upon factors such as equipment capacity, furnace pressures, type of load & design of furnace. The burners can be supplied with blower, control panel, oil pumps, oil preheaters, duplex filters & gas trains etc.
Jayyesh Krishnani (Lafil Engineers and Associates)
9,Anurag Chs, Model Town, Seven Bunglows, Andheri(w). Mumbai, Maharashtra - 400053, India
Share us via
Write a Review
