GST : 33AAACL6858Q1ZV
Write a Review
Our Products
Traub collets using for work piece clamping and bar or chuck work. No axial movement while the chuck is clamping. The collets are made from special spring steel. Where possible, by partial tempering the hardness of the taper and clamping bore is approx. 60 HRc. The shank and spring area are hardened to spring. Bore smooth and with round grooves More..
Traub collets using for work piece clamping and bar or chuck work. No axial movement while the chuck is clamping. The collets are made from special spring steel. Where possible, by partial tempering the hardness of the taper and clamping bore is approx. 60 HRc. The shank and spring area are hardened to spring. Bore smooth and with round grooves from 6.0 mm, serrated in the case of round bores greater than 9.0 mm for higher clamping force. The clamping taper is lightly ground at the slot edges to ease removal of the collets from the mounting thus making possible low undersized clamping. The taper of the clamping sleeve should be 15 per side flatter than the taper angle given in the tables. This frees the collets on release and provides low undersized clamping. In the case of stepped bores or when using collets stops the clamping point should be within the taper of the collet, otherwise the collet will tend to break due to bending stresses.
Additional Information:
Packaging Details : SPECIAL & STANDARD
Delivery Time : As agreed
Traub collets using for work piece clamping and bar or chuck work. No axial movement while the chuck is clamping. The collets are made from special spring steel. Where possible, by partial tempering the hardness of the taper and clamping bore is approx. 60 HRc. The shank and spring area are hardened to spring. Bore smooth and with round grooves from 6.0 mm, serrated in the case of round bores greater than 9.0 mm for higher clamping force. The clamping taper is lightly ground at the slot edges to ease removal of the collets from the mounting thus making possible low undersized clamping. The taper of the clamping sleeve should be 15 per side flatter than the taper angle given in the tables. This frees the collets on release and provides low undersized clamping. In the case of stepped bores or when using collets stops the clamping point should be within the taper of the collet, otherwise the collet will tend to break due to bending stresses.
Additional Information:
Packaging Details : Standard & Special
Delivery Time : As agreed
V.Saravanakumar (Lexis Tooling Systems Private Limited)
7/301, Eloor Road, Eloor Post, Pollachi Main Road, Pollachi Taluk, Coimbatore, Tamil Nadu - 641032
Share us via
