Measurment Systems of Liquids & Gases

Alandi, Pune, Maharashtra

venturi flowmeters for most liquids, slurries, gas applications .

we manufacture this type of flowmeters for pharmaceuticals, sanitary, chemical industry applications which requires stainless steel 316l body only. also some flowmeters are manufactured in teflon and other materials as per requirements if required for cost effectiveness and light weight. the above flowmeter has a turbine of ss316l

milk meter for all line sizes , pressures, temperatures & all flow rates the flowmeters are compiatble of taking inlet milk with accuracy of 0.5% and the flowmeters can withstand 160 degree celcius so that they can be used for the cip, sip with an ease.

within the working range of the meter the rotor spinsproportional to the actual velocity of gaseous materialflowing. a pick-up coil produces an electrical signal aseach blade crosses through its low magnetic or rffield. this signal is amplified and conditioned by atransmitter or fed directly into a rate/totalizer, and representsthe actual cubic feet per minute (acfm) flowingthrough the meter. the k-factor is stenciled on themeter body in pulses per actual cubic feet (p/acf).because gases are compressible, most people desireto measure the equivalent amount of gas corrected forthe line pressure and temperature to standard cubicfeet per minute (scfm at 60f, 14.69 psia). if theflow temperature and pressure are relatively constant, then a simple correction can be calculated to shift thek-factor from p/acf to p/scf and a simple totalizer(measurement systems india make ) may be used. when flowtemperature and pressure are not constant, a flow computer. specificationslinearity 11.0%/0.5%repeatability 10.25%maximum over-range125% of flow rate for intermittent periodsfrequency output0 to 1, 100 hzvoltage outputapproximately 100 mv@ 100 hz to 1.5 v (rms)@1, 000 hz.pressure drop0.5 psi at 100% of flow rangepressure rating we manufacture flowmeters for most pressures. installationvertical or horizontal (any direction).materials of constructionbody: 316 l stainless steel.flanges: 316 stainless steelrotor: 431 stainless steel.rotor shaft/bearings:standard: tungsten carbide v-cupcartridge frame retainer: 302 stainless steelcartridge frame: 316 l stainless steel.temperature range:meter with bearing structure of:standard: tungsten carbide: -40f to 300f (-40c to 149c).for other temperatures consult factory.