MGM Engineering Corporation

Shivane, Pune, Maharashtra

Cylindrical plain ring gages are used to check outside diameters of parts as well as for mastering measuring instruments. Plain ring gages are used to set electronic bore gages, air gages, internal micrometers and length measuring instruments. Plain ring gages are ideal for gaging the outside diameter of parts. The go ring gage is used to verify the high limit of the part and the no go plain ring gage is used to verify the low limit of the part

Manufacturing Capabilities:-

1. Plain Ring Gauges6mm to 150mm
2. Blank DesignIS-3485 / DIN 2250 C /ANSI B.47
3. Gauging PracticeAS PERIS3455.Class. X as per ASME B89.1.5

• AIR PLUG
• Checking internal measurement
• 2 Jet Air plug from 4 to 100mm
• Hard chrome plated

• AIR RING
• Checking external measurement
• Air Ring with two jets tomeasure size, taper and ovalityand three jets
• Range for diameter 4 mm to100mm

• AIR SNAP
• Checking external measurement for shafts, crankshafts Pin and Journal diameter
• Corner jet or middle jet
• Tungsten Carbide measuring faces and rest pads
• Range 10mm to 100mm

• Model 1 A gives most economical solution to inspection needs
• High speed of response and self cleaning of gauging areaensures accurate reading of parameters
• High accuracy and linearity
• Non-contact gauging so, no or minimum frictional wear.
• Requires Two setting masters for correct linear setting
• Minimum line pressure requires 4.5 bars
• Air consumption 50 LPM
• Every gauge carries a calibration certificate

• Single Channel tri color bar graph and Six Digit Display
• Inch and metric Ranges
• Compatible with Half bridge and full bridge LVDT probe
• Absolute / Comparative measurement
• Static / Dynamic measurement
• Pneumatic converter with 1 input when supplied with this module
• Pneumatic converter without flow control valves
• RS-232 serial port for PC connectivity
• External relay output
• Sleek and thin enclosure design
• Fixture selection or model selection facility provided. 16 fixture data saved
• Optional 5000 readings storage facility

Pin, Tri-Lock and Taper-lock gauges have a number of features which can be added to suit a particular application.

MGMs experienced, specialist gauge makers have considerable experience in applying these features against the customers component drawing requirements.

• Extended length gauge members.
• Progressive (Stepped) gauge member, Go, No Go.
• Progressive (Stepped) gauge member for inspecting concentricity.
• Hexagonal gauge members.
• Air Release flat on the Go member.
• Depth steps on the Go member
• Pilot Entry lead-in chamfers.
• Leading face on Go member relieved to clear a protrusion.
• Extended length handles.
• Handles marked with customer specific information.