t's universal design enables it to calibrate both plunger and lever DTI's (Dial Test Indicators). It can also be used for calibration of bore gauges. The unit also determines gauge hyteresis which is not possible using conventional gauge blocks. This dial gauge calibrator can be used in calibration laboratories and also be used for roaming shop floor gauge calibration checks as it is a portable device. The test is performed by comparison with the master gauge. The calibrator uses the Abbe's principle. SPECIFICATIONS :25 mm travel covering the majority of common indicators Accepts lever indicators with stylus up to 40 mm long Computer interface for efficient calibration reports. Plunger dials with 8mm or 38 shank can be tested. Bore gauges up to 150 mm can be checked. The standard Kit incorporates, Cary case ModelDGC-25 calibrator Master gauge (Baker Electronic Dial Gauge ED1) RS 232 cable to transfer output to computer with software Magnifying glass 38 to 8 mm stem mounting sleeve. Bore Gauge holding bracket and extension rod. For more details and enquiry please contact.
Write a Review
Micron Instruments Co. (Micron Instruments Co.)
Flat No. 1, Building No. 9-A, Paschima Nagari Near City Pride Kothrud, Pune, Maharashtra - 411038
Share us via
