Mukta Engineers

Kalyan West, Mumbai, Maharashtra

These are ventilators which are electrically powered by motors. Typical Application areas are where continuous exhaust of very high volume of air is required at specific interval for specific durations. E.g. Casting Melting Foundry , Chemical Plants , Steam Plants etc. The efficiency of Conventional Ventilators is dependent on wind velocity. The wind velocity may not be adequate at times when maximum exhaust is required. The Motorised Ventilators provide an option for exhaust of polluted air during such specific events. When used alongwith conventional ventilators they can provide very efficient exhaust with minimal power consumption. The efficiency of Conventional Motor driven exhaust is compromised when installed on walls mostly nearby windows and doors. Most of the air being exhausted is sucked from windows or doors nearby instead of the apex of the premises where maximum hot air accumulates. Installation of Motorised Ventilators on the apex is the best location for providing maximum exhaust of hot airsmokegases.

This Aluminum Roof Ventilator is guaranteed for long lasting performance. Constructed from light-weight aluminum as it has 1/3rd the weight of steel and thus the inertia required to move the ventilator from stationary position is much less.

Aluminum being highly ductile and malleable facilitates complex design of aerofoil blades of the ventilator. These exclusive blades are designed to generate maximum resistance to the wind flow thus producing the rotational push. The Aerofoil blades also incorporate intricate grooves that guides out the rain water falling on it and prevents the same from percolating inside the premises.

These Ventilators constitute a system of noiselessly passing the outside air to the roof and attic space. Increasing temperature, heats up the air which rises to the highest point of the roof and passes through the gaps in between ventilator blades naturally drawing cool outside air to replace the air that has just left, allowing efficient air-flow.

Roof ventilators can be installed with minimum interference to the existing roof structure, and can be supported by the colors and textures to match your roof.

Extraction is the process of forcefully removing trapped air from factory shed creating a vacuum or low pressure zone, which is then neutralized by drawing of cool air from outside and completing the convection cycle. Depending on the size Roof Extractors exhaust large amount of the heat & smoke accumulating at roof level of the factory. They are ideally suited in Boiler , Steam Foundries, Forge shops, Heat Treatment shops and Automobile factories.