GST : 07ALFPR0625N1ZUOur Products
Leading Manufacturer, Supplier & Retailer of COMPRESSION TESTING MACHINE (Four Pillar) Three Pressure Gauge, Semi Automatic Servo Compression Testing Machine, Digital Compression Testing Machine, Cube Compression Testing Machine and Semi Automatic Compression Testing Machine.
Standard Used : IS 516, BS 1881
Specification: The load frame is made up of high quality steel construction with a fixed. Upper lead carrying a ball seated platen. 4 pillars are fixed to the base and the top plate of the loading frame. The upper and lower plates are adjusted with the help of head screw on either side of the pillar. The ram dia of the machine varies from the requirements of the customer. The lower pattern are at the base of the frame above the ram and it is rectangular in shape. Sufficient clearance is provided between the platens to fit in the cylindrical/ cube moulds. Spacer provided to adjust cubes and cylinders. A 20 cm dia pressure gauge with maximum load induction pointer is fitted on the top panel and in turn is connected to the hydraulic pressure pipe. On the right hand a console is fitted within which the electrical motor is fitted along with its coupling which inturn is connected to the pumping unit. A slow / fast loading rate regulator fixed on the top of the console for adjusting the rate of loading. The machine is duly calibrated and passed after inspecting and analyMSIng it with a compression level indicator is provided as a dip stick.
Additional Information:
Payment Terms : D/P, T/T
Packaging Details :Wooden Box
Our semi automatic compression test machine is available from 100 Kn to 3000 KN
Load frame frame can be supplied, in Chanel type, 4 pillar type, Plate type
Provided with software.
speed controlled by control know/simulator.
power required 440V, AC supply, 50 Hz
Additional Information:
Payment Terms : D/P, T/T
Delivery Time :8-10 days dispatch
Digital Compression Test Machine
100 kn to 3000 Kn capacity
Standard Used : IS 516, BS 1881
Specification: In these load frames “C” channels are used, they are welded at the top as well as bottom and with stand high loads. A hydraulic jack is fitted at centre of the base of the load frame, over which can be fitted lower platen and spacer block with the help of centering pin. A lead screw passes through the top of the frame. To the lower end of this lead screw is fixed the upper platen with spherical seat for self alignment. The platens are accurately machined, hardened and polished. The lower platen grooves to correctly place the specimen. Note: The platens are normally rectangular on shape, but no special request square platens or circular platens can be supplied at an extra cost. Ranges: 50 kN to 2000 kN
Additional Information:
Packaging Details :Wooden Box
Raj Bhardwaj(Multitech Scientific Instruments)
B-18, Gali No. - 9, Anand Parbat, Industrial Area, Delhi - 110005
Share us via 
