Naman Enterprise

Shahdara, Delhi

The Clich or Steel Plate is the carrier of the print that will be required on the product or component.Traditionally the plates are generally of thick steel material which is made by a very special process of hardening and etched by chemical milling process. As clichs or plates for pad printing have very high importance hence selection of proper plates or clichs is extremely critical for quality. Varying types of clichs are used depending on the desired print quality and quantity. The motif is recessed, etched into or washed out of the clich. In order to assure smooth fitting and printing, the motif should be at a distance of at least 25 mm (1 inch) from the outer edge, and centered on the plate. In the case of long or fine lines, the motif must be at an angle of approx. 5 to 15 to the blade track in order for the doctor blade not to dip too low and scoop out too much ink. Numerous trials have shown that an etching depth of 30-35 ?m is optimal for pad printing. Since the pad can only transfer a limited quantity of ink, a greater depth is pointless. At an etching depth of 30-35 m, the pad only picks up an ink film of 12 m. The rest remains in the depressions of the clich. Because the ink film consists of approx. 40 % to 60 % thinner, which evaporates during the transfer and drying, the actual thickness of the ink film left on the substrate comes to around 5 m - 8 m, in some cases, as little as 2 m. As an exception to the above statement, very fine fonts are etched at approx. 15 m, and very large motifs, at approx. 30 m. For very large surfaces, the dip of the doctor blade can be avoided by additionally copying a fine screen into the motif.

Our Clich is produced from special tool-grade, abrasion-proof steel.Its area of application is found primarily in the industrial sector. Steel clichs are especially suited to high quantity printing runs and closed ink systems. The quality of these clichs is unequaled. This is evident from their absolute sharpness of contour, multi-stage etching, utilization of screens of all types, very fine surface, low susceptibility to physical damage and consistency in high quantity printing runs. The number of prints which can be achieved using this clich comes to at least 1, 000, 000 doctoring operations. These plates are sized, ground, toughened, lapped, polished and etched. The whole process cycle take about 25 days. Hence standard sizes are mostly in stock and special clichs/ plates need time.