Write a Review
Our Products
Our product range contains a wide range of Stainless Steel Repair Clamp, SS Half Circle Repair Clamp, KWIK Tap, KWIK Finger Repair Clamp and Handiband Repair Clamp
The pressure on which the clamp can be used will vary with the type of clamp, pipe OD, medium etc. Use the following table as a guide (recommended working pressure, in bars, under ideal circumstances) :
It is one band clamp (SS Half circle repair clamp) with partial gasket. For the repair of small holes in pipes with OD from 21 mm. up to 323.9 mm. Working range 4 mm. for smaller size & up to 10 mm. larger sizes Available forW. P. up to 300 P51(20.4 Bar)
A range of tapping clamps that provides a quick, cost effective method of installing or replacing service pipe connections, whilst under operating pressure. Kwik Tap can be used with standard drilling equipment.
These repair clamp provide an economical and permanent method of repairing damaged pipes from pin hole leaks to full 360 circumferential breaks. These clamps are light weight and easy to handle. Range : DN40-DN600.
This repair clamp is for quick repair of leaks or holes in pipes. The installation is fast and simple. Just snap the clamp around the pipe. Drop bolt head through open-slotted lug. Tighten the nut. Range : DN15-DN400.
These Clamp can be easily and quickly be assembled by just tightening four captive bolts and guarantees leak-proof repair of pipes. Useful for taking branch connections off existing water mains even under pressure. Range : DN50-DN300.
J P Goenka (Nanda millar Co)
1/2 chanditolla branch road, Behala, Kolkata, West Bengal - 700053, India
Share us via
