Special Features

• Pre assembled, factory tested systems, compact, easy to install, operate and maintain

• FRP pressure vessels, PVC piping & valves

• System requires only water, electrical and drain supply and can be installed in a day.

• Auto control valves for easy operation of system and electrical controls with all interlocks

• Well packed - resin media to provide good filtered water quality.

• Solution tank of required volume and test kit for water quality check.

• Sampling points for quality monitoring and pressure gauges for pressure monitoring and conductivity meter for continuous water quality monitoring

Special Features

• Instantaneous flow rates up to 20 m3/h
• provide up to 400 m3/day on a feed water of 100 ppm total anion feed.
• Average resistivity of purified water is 0.5 mS/cm, with low running costs.
• High chemical efficiency - high purified water output from low regenerate chemical usage.
• Smaller footprint and higher flow rates than conventional plant.
• 30 minute regeneration time.
• Reduced outage time can often eliminate the need for duplex plant.
• Near neutral effluent reduces disposal costs.
• Stainless steel process pump fitted as standard
• Automatic control by PLC
• Message display provides continuous read out of system status
• Flow display provides information on flow rates, throughput and number of regenerations.
• Audible alarm and 'no flow' alarm circuit
• Can be connected to level sensors in chemical tanks to prevent regeneration when insufficient chemicals are available.
• Minimal installation and commissioning costs.

Special Features:

• Pre assembled, factory tested systems, compact, easy to install, operate and maintain

• FRP pressure vessel, PVC piping & valves

• System requires only water, electrical and drain supply and can be installed in a day.

• Multi port control valves or individual valves for easy operation of system and electrical controls with all interlocks

• Well packed - resin media to provide good filtered water quality.

• Solution tank of required volume and test kit for water quality check.

• Sampling points for quality monitoring and pressure gauges for pressure monitoring and conductivity meter for continuous water quality monitoring

Treated water quality at the outlet of the unit is having conductivity less than 1 – 2 micro Siemens/cm with neutral ph.

Special Features:

• Pre assembled, factory tested systems, compact, easy to install, operate and maintain

• Mild steel rubber lined pressure vessel, msrl piping & ciel valves

• System requires only water, electrical and drain supply and can be installed in a day.

• Multi port control valves or individual valves for easy operation of system and electrical controls with all interlocks

• Well packed - resin media to provide good filtered water quality.

• Solution tank of required volume and test kit for water quality check.

• Sampling points for quality monitoring and pressure gauges for pressure monitoring and conductivity meter for continuous water quality monitoring

Treated water quality at the outlet of the unit is having conductivity less than 1 – 2 micro siemens/cm with neutral ph and with Two Oass Mixed Bed Unit, same is 0.05 Micro Seimens/cm or less than 18 mega Ohms

These systems are widely used in for producing water for Pharma, Bulk Drug, Power Plants, Co-generation,