Manufacturer / Exporter / Supplier / Retailer Of Spot Projection Welding Machine, Semi-Automatic Seam Welding Machine, Drum Side Seam Welding Machine, Can Side Seam Welding Machine, Longitudinal Seam Welding Machine, Circumferential Seam Welding Machine, Conical Stretch Forming Machine, Small Can M... Read More
Robust construction with maximum resistance to deflection. Welding Transformer enclosed in the frame. Pneumatic accessories mounted on the side of the frame. Welding Transformer : Water cooled, class “F” insulation with thermo switch protection from over heating. Current Control : Welding current adjustable from 50% to 100% by tap switch. Cooling System: Thyristor, Transformer, secondary connection and electrode wheel are water cooled. Electrode Force: Upper ram is actuated by pneumatic cylinder controlled by solenoid valve.Compressed air at 2 ksc to 5.6 ksc provide the electrode force. Electrode Drive : Machines are provided with different drive system depending on the application. Customer has to specify the system. 1) Direct Drive : Direct gear drive is given to any one of the wheels. 2) Knurl Drive: One of the weld wheel or both the weld wheel driven by a serrated hardened wheel depending on type of weld. Constant dressing of weld wheel maintain uniform profile. Constant linear welding speed irrespective of weld wheel diameter. Motor Drive : Machine will be supplied with geared motor and AC speed drive. Electronic Control : 1) A squeeze time control adjustable from 2-25 cycles to select delay between initiation of the foot switch and the start of the weld. 2) Synchronous timing of 1-9 cycles “ON” and 0-9 cycle “OFF” both in step of one cycle each for weld time. 3) Phase shift heat control for firing the thyristors and to adjust the welding current between 50 and 100% over and above the transformer. 4) High power switching device consisting of two thyristor connected in inverse parallel and mounted on a water cooled heat sinks. Protective devices for high voltage surges and thermo switches are standard feature. 5) Hold time having a range of 2-25 cycles to provide a delay between stoppage of weld and separation of weld wheel. SERVICE FACILITIES (To be provided by customer) Power Supply: a) For Transformer: 415V single phase 50 cycles (suitable for connection to 2 lines of 3 phase supply). Main supply cable for transformer connection. Disconnect switch with fuses of recommended rating. b) For motor: 415V, 3 phase 50 cycle for A.C. motor drive. Supply cable 1.5 sq. mm. & 3 core, Switch fuse unit 500V, 15 amps, A.C. Motor Drive system. Compressed Air: Supply of air at recommended flow volume at 5.6 ksc. Cooling Water: Water at 2.6 ksc pressure and below 30 degree C. at recommended flow rate.
Share your thoughts with other customers for Nospark Engineering
Add Review
