GST : 09AABCR8577R1Z9
4.6/5
Our Products
The Hot metal ladle shall be of circular design with all welded construction and reinforced by two stiffener rings with special reinforcement in the area of the trunnions. The material for the ladle shell and bottom shall be Gr 2 as per IS:2002 (latest revision) or E 250 B as per IS 2062 (2006) or as per the customer specification. The bottom of More..
The Hot metal ladle shall be of circular design with all welded construction and reinforced by two stiffener rings with special reinforcement in the area of the trunnions. The material for the ladle shell and bottom shall be Gr 2 as per IS:2002 (latest revision) or E 250 B as per IS 2062 (2006) or as per the customer specification. The bottom of the ladle shall be made of a single plate and shall be dished. The ladle shell and bottom shall be designed for a maximum operating condition of 4000C. After complete welding, the ladle shall be stress relieved. The flat ladle bottom is furnished with an opening for the base plate (by others) for fixing the slide gate.
The trunnion and trunnion plates of the ladle shall be made of forged steel of grade 20 C8 or 30 C8 as per IS:2004 (1991). The trunnion plate shall be annealed after forging and shall be ultrasonically tested for soundness. The forged trunnion pins are welded into the trunnion ring and into the ladle shell. Three ladle foot are welded to the ladle bottom to permit placing on ground floor. The trunnions shall be designed with a minimum factor of safety of 8. Suitable flange shall be welded inside the ladle for retaining the permanent refractory lining.
Tilting Mechanism
The ladle shall be provided with tilting mechanism outside the shell for tilting. A tilting device is provided at the ladle bottom which is designed so that the tilting hook to the crane can be engaged and/or disengaged without manual help. Seats of suitable design shall be provided under the trunions for placing the ladle on the turret of the continuous casting machine, transfer car and ladle stand.
Vent holes shall be provided at suitable spacing on the shell and bottom plate. The ladle is equipped with one bayonet for fixing the porous plugs as well as the piping installation to the porous plugs.
Additional Information:
Payment Terms : L/C, T/T,
Delivery Time : 1 Month
Rahul Ranjan (Remso Control Technologies Pvt. Ltd)
D-157, Export Promotion Industrial Parks, Gautam Budh Nagar, Kasna, Greater Noida, Uttar Pradesh - 201310
https://www.furnacescrappoker.com
Share us via
