The "USB Servo Controller with ADC" from Rhydolabz is a very compact solution for controlling up to eight RC servos from a PC . Each servo speed and range can be controlled independently. The user could control the servomotors by sending the desired command through USB from PC. Once connected to PC module will enumerate as Virtual COM Port . So any Program that can access RS232 can use to control this module. Servo Controller supports two protocols Mini SSCII and RHYDO-SSC protocol. The built in 2 ADC Port can be used for measuring any analog voltage ( ie. 2 Sensor values) and the other ADC channel is permanently connected to measure Servo Voltage. With appropriate command from host the module will do ADC conversion for the selected channel and send out the result via USB. This feature is extremely useful for monitoring any sensor value while controlling the servo and to detect the battery low condition.Features:Compact High Quality Two layer PTH PCBProfessional EMIRFI Complaint PCB Layout Design for Noise ReductionSupport Mini SSII and RHYDO-SSC Protocol3 Channel ADC measurement using commandServo voltage measurement using commandOnboard EEPROM to save Configuration ParametersSupport USB 2 On Board Status LED IndicatorCan set Neutral Point for each servoOn Board EEPROMMini SSII Mode in default and ready to use .Specifications:Number of servo ports: 8 NosPulse Width Range: 0.25 to 2.75msResolution: (0.05 degree)Supply voltage: 5 -16V Baud Rate: 9600-115200Current consumption: 5 mA (average)
Write a Review
Mr. Rhydo Technologies (P) Ltd (Rhydo Technologies (p) Ltd.)
4th Floor, Golden Plaza, Opp. Mymoon Theatre, Chittor Road Pincode: 682018, Kochi, Kerala
Share us via
