Other Products / Services #864662

A Poppet type Flow switch for various medium for generating signals when the flow exceeds/drops below safe limits. It has construction in various materials like brass, Nylon, PP, Stainless steel.

A fuel oil shut off valve with viton rubber bonded during molding to an metal disc and is finished to a close tolerance.

A device to give proportionate resistance out put with increase/decrease in pressure. This has a built in low pressure switch.

A device to aid cold starting of the engine mounted on suction manifold.

A device to indicate / control the vehicle on application of breaks or give signal to safety unit or tail lamp.

A solenoid used in hydraulic valve having 4-6 cycles per second. Fully epoxycated & sealed. The force diagram can be developed as per customer demands.

A device to break the elevator at various levels. This is a extremely critical continuous duty application.

A Hall Effect Sensor Giving Square Wave Output Proportional To The Rpm Of The Toothed Wheel.

A device based on piezoelectric principal with (Ceramic Sensor) to give proportionate output with respect to increase / decrease in pressure. The device has option for two built in switch output. The same device is suitable for 12V and 24V.

An Electro-mechanical device, torsion spring loaded during operation which on failure of V belt changes its contact from NO to NC, actuating the system to switch off the diesel engine.

A device with an "ON" delay which will automatically switch on a contact after a preset delay. Typically used in auto idling for earth moving equipments.

It indicates the oil level in oil tank. This has toughened glass as sight medium.

A compact combination of lock which can be triggered from a remote location . It is a combination of lock & solenoid in one assembly assisted by returns spring.

This is an compact solenoid for automobile applications. This has a built in timer to release the plunger after a preset timing. The trigger is taken when the key switch disconnect supply to the signal terminal. It has a built in frequency modulator to minimize the energy consumption & heating.

An external device to heat the water in the cylinder block jacket with built in temp controller. No major modification required on equipment. IP 65 compliant.

An PU/PP/Nylon float operated device where depending upon the level of liquid (fuel) due to Magnetic linking of flux reed switch is operated to produce electrical signal.

An stainless steel float operated device where depending upon the level of liquid due to magnetic linking of flux operates a reed switch to produce electrical signal. A all SS construction is also available for harsh environment.

A device to heat the air in a control panel, room, cabinet. These devices are available in various wattage & voltage as per customer requirement.

A device used to heat suction manifold air for cold start application. This reduces the white smoke emission while cranking.

An Electro-mechanical Device to give switching change over controls from "NO" to "NC"

A device to give a proportionate resistance output with increase/decrease in temperature. An arrangement of builtin high temperature switch can also be provided.