Our Products
6 litre capacity for vital capacity, or use as a gasometer with chain compensated counter balance to the float balanced through cut its movement. Pulley calibrated to denote volume inlet and outlet tubes, side cock for gases, cock for draining off water strong construction. Complete with corrugated tube mouth piece & recording lever. |
A versatile, electrically heated sterilizer under saturated steam of Adjustable pressure of 10 to 20 psi. double walled construction with boiler & steam jacket made of thick stainless steel and gap is filled with high grade glass wool to bring the temp. loss to a minimal level.The outer chamber is made out of thick mild steel.The lid is made of thick stainless steel plate (joint less) or gunmetal plate and can be sealed by a jointless neoprene rubber gasket by wing nuts through hinged bolts by engaging slotted lugs on rim of the cover. Provided with dial pressure gauge, air/ steam release cock, spring loaded safety valve adjustable to any required point from 10 psi to 20 psi with accuracy + 3 psi. A drain cock has also been provided. A double safety valve has also been provided along with inlet. Supplied complete but without dressing bins. |
Optional:- i) Automatic low-water level cut off- device. ii) pressure Control switch. iii) Water lever arrangement. iv) Dressing bins for various size. |
Vertical | ||||||||||||||
|
||||||||||||||
Body in made of one-piece aluminium and is logged with special mineral wool. The panel is provided with on-off switch, energy control knob, pilot lamp etc. Provided with jointless hand knitted heating nets of glass yarn capable of withstanding high temperature upto 400oC. Single supplied complete with cord & plug to work on 220 V AC 50 Hz single phase. Single circuit system has been adopted. | |
Laboratory hot plates are available in round and rectangular shapes. Body is fabricated out of thick mild steel sheet duly finished in stoving enamel paint. The hot plate made of cast iron, nicely & Precisely machined & smoothed duly finished in heat resistant black paint is firmly mounted on the body. Heavy duty heating elements are securely layed under the plate to operate on 220 V AC 50 Hz single phase. Temp. is controlled by a three-heat rotary switch along with an indicator lamp for the mains and cord & plug. |
A) HOT PLATE : (ROUND) Single B) HOT PLATE (Round) Double C) HOT PLATE (Rectangular) Specifications as above but plate is rectangular in shape. |
Specifications
A | B | C | D | |
Working Chamber | 2'x2'x2' | 3'x2'x2' | 4'x2'x2' | 6'x2'x2' |
Size of HEPA Filter | 2'x2'x6" | 3'x2'x6" | 4'x2'x6" | 3'x2'x6" |
No. of HEPA Filter | 1 | 1 | 1 | 1 |
No. of HEPA Filter | 1 | 1 | 1 | 1 |
Illumination | 1x20W | 1x20W | 1x20W | 2x20W |
U.V. Germicidal Light | 1x1½ ft | 1x1½ ft | 1x3 ft | 2x3 ft |
Standard Specifications
4 digit LED display 0-9999, audible buzzer confirmation of each count, electronic auto marker counting ink pen, digital count display can be reset at any time by RESET KEY suitable for dish size 110mm. having 1.7x magnifying glass with focusing system, input supply 220-230VAC 10%.
Standard Accessories
Electronic Counting pen, 1.7x magnifying glass, dust cover, instruction / working manual.
Double wall construction, inner being made out of highly polished thick stainless steel and outer made out of thick mild steel sheet finished in stoving white enamel paint or staple mat colour combinations. The gap is filled with special glass wool for temp. insulation. The bath is provided with the drain cock to easily drainout the water and clean the chamber when required. A pyramidal shaped cover is provided
Immersion type heating elements are fitted at bottom. Temp. range 5o C above ambient to 80o C with accuracy + 0.5oC to 1oC is controlled by capillary thermostat regulated by a graduated knob on the panel, which is also provided with pilot lamp etc.
The equipment is workable on 220V AC 50Hz single phase. The baths are supplied without racks, thermometer and stirring arrangement.
Compact stirring device utilizing a rotating magnetic field applied from below the container. The stirring is accomplished by a taflon rotor placed in the liquid to be stirred. Complete with pilot lamp, plug cord, continuously variable speed regulator The body is made of mild steel duly finished in stoving enamel and mounted with a stainless steel top which serves as a hot plate. Stirring and heating units are properly insulated. In model with heating system temp. is controlled by an energy regulator. An electronic speed controller is also provided. The equipment works on 220V AC 50 HZ single phase. |
I) Magnetic stirrer with hot - plate cap. liter, 2liter , 5tliter , 10Liter |
Built-to-last, Rust proof, Shock roof durability un-matched,
with all ABS body
Whisper quit blower cooled very fine focusing system provided
24150W halogen lamp
Thermocal packing for safety transportation and idle for repacking.
Electrical E-8 Student Kymograph with special heavy duty motor, oil lapped gear systems, speeds from 0.12 mm/sec to 640 mm/sec, in 8 steps, jerk free running, instantaneous start & stop clutch. Stainless steel spindle with screw lift 15 x 15cm cylinder with levelling screws, pilot lamp, plug & cord. |
12" Dia, Stainless Steel : The machine is worked by oil immersed gearbox with 1/4 H.P. motor driven, or by heavy duty DC geared motor. Air blower is operated independently and air is thermostatically controlled to give temperature 30, to 110, C. Switches for motor & blower are fixed on a panel with neon indicators. Also mains lead with 15 Amp plug provided. |