We are offering AMF Cum Synchronizing Panel which is based on load in KW. Hence the actual sharing, starting, stopping & transfers are actual load dependent & not on any other unrealistic parameter like voltage, current. etc. Changing of scheme becomes very easy because of changes are made through software only. There is no changing of wires, adding of components like relays, contractors, which is very time consuming, cumbersome & requiring additional space. Along with KW sharing, KVAr sharing & PF sharing is very accurate, because of PLC programming. There is no possibility of any unequal sharing as regards KW, KVAr & PF. For any type of load addition or reduction, manual intervention as regards D.G.set operation is not required. However, in case of emergency manual override is possible. Special programmers using Real Time Clock (RTC) are possible. Because of KW dependent load sharing, optimum utilization of D.G. sets are possible. This increases D.G. sets efficiency & saves lot of fuel. D.G.sets are always tried to run with 80 % to 90 % load factor, where we get maximum efficiency of D.G.sets. This is easily possible with our system. We are well-known manufacturers of Automatic Mains Failure Panel including Protection for DG sets. It uses an advance technology to make an easy and trouble-free Gen set control. Basic Operation Cycle When there is mains supply, the AMF Panel will keep the load on mains, once the mains supply fails, the AMF Panel senses this and starts the Gen set. Once the Gen set is found running, the load is transferred to Gen set supply. When mains resume, the load is transferred back to mains supply and Gen set is stopped.
Write a Review
Rohit Khorat (Sai Raj Groups)
1021/B, Off. No. 6, Girnar Classic, Opp. Padamjee Compound, Nr. ICC Cable Networks, Nana Peth, Pune, Maharashtra - 411030, India
Share us via
