SAUMYA TECHNOCRATES

Kathwada, Ahmedabad, Gujarat

ASTM D 1238 METHOD A & B, ISO 1133, IS 2508/2530, BS and other equivalent standards.

Melt Flow Index Tester

Model: MFI-AE

(Manual Model)

Melt Flow Index Tester

Model: MFI-AC

(Semi Auto Model)

Melt Flow Index Tester

Model: MFI-AFA & AFB

(Fully Automatic Model)

Melt Flow Indexer is used to measure the flow rate of different polymers. The reported Melt Index values helps to distinguish between the different Grades of Polymers. This is due to the fact that plastic materials are seldom manufactured without incorporating additives, which affect the processing characteristics of material like stability and flowability.

The "Saumya" provides MFI tester with customized controller keeping in mind the process of test.Single Instrument with Temp. cont. and Timer.Precise temp. with accuracy of +/- 0.1 C.Microprocessor based digital timer with facility to select number of test, cuter time, buzzer indication on completion of test and advance buzzer indication for manual cutting procedure.Fully Automatic MFI is having facility to conduct to test independently by pre-setting the temp. of test, time & applying the required Load and it will directly give the result of MFI for individual test & average of all test.

"Saumya" provides impesct tester for different plastic films, sheets, Decorative laminates, corrugated roofing sheets etc. with range of Darts & selectable facility of height of fall with low efforts.

"Saumya" provides two different Electromagnetic system for light & heavy Dart respectively which would help in selection of dart with smallest possible dart to heaviest one.

"Saumya" gives high tech vaccum pump with gauge and clamping system to clamp the film tightly. "Saumya" provides digital counter for counting no. of test.

ASTM D 256 AND OTHER EQUIVALENT STANDARDS

Impact Strength is the Mechanical property of polymer and as molecular flexibility plays an important role in determining the relative toughness of materials. For any molded plastic this test plays an important roll.

The "Saumya" Impacto Meter is designed and built according to National and International Standards. Dial with clear and five different scales for energy selection.

The "Saumya" Digital Imecto Meter is having versatile features with high accuracy to measure Izod / Charpy Test upto range of 1 to 25 Joules.

Interchangeable parts for Izod and Charpy test.

Two hammers each for both the test with extra load attachments.

Water Bath for Large Diameter Pipes

As per plastics are affected by the temperature, Hydrostatic Pressure tests for HDPE, R-PVC, C-PVC, U-PVC, MDPE and lateral pipes test specimens are suppose to be tested either at room temperature, at higher temperature or lower temperature in water bath as per national & international standards.

"Saumya" baths are uniquely designed to heat faster with low energy cost and to maintain the temperature for longer time. To maintain the the temperature into the bath circulation is done by either one or two pumps as depending on the volume of bath.

Temperature is controlled by microprocessor based controllers. In large size bath "Saumya" gives separate bath for heating & the hot water is circulated to the other chamber so as to save the energy cost.