Nuts Bolts And Fasteners #5941346

NPT (National Pipe Thread) seals are the most popular type of seal for pressure calibration systems in the U.S. and Canada. NPT male adapters have a taper thread that wedges into the female NPT adapter. They seal due to the "out of roundness principle" which means that the male stretches the female fitting until there is so much force that the connection can hold pressure. One of the challenges with this design is that if you connect stainless steel to stainless steel then over-tightening or poor lubrication can cause gauling and damage to the threads. Thread sealant is needed to seal but only 2 turns of thread sealant is required. Any more than that and the seal can leak around the thread sealant.

A bonded seal is a type of washer used to provide a seal around a screw or bolt. Originally made by Dowty Group, they are also known as Dowty seals or Dowty washers.Now widely manufactured, they are available in a range of standard sizes and materials. A bonded seal consists of an outer annular ring of a hard material, typically steel, and an inner annular ring of an elastomeric material that acts as a gasket.

Male Bulkhead Connector has an interface type of solder cup and a 50 Ohm impedance. Pasternack Male bulkhead Connector uses shield/contact solder as an attachment method. Our Male Connector provides a minimum frequency of DC and a maximum frequency of 18 GHz.

The Pasternack Male Bulkhead Connector has a teflon dielectric type and a VSWR of 1.23. The Pasternack SMA terminal connector has a passivated stainless steel body. Our PE4354 Connector uses brass contact. This Male bulkhead terminal RF connector is RoHS and REACH compliant.

This Pasternack Male Bulkhead Connector will ship the same day as purchased. Our bulkhead Male Connector is part of over 40, 000 RF, microwave and millimeter wave components in stock for worldwide shipment. We also build custom Connector cable assemblies that will ship the same day as well.

NPT (National Pipe Thread) seals are the most popular type of seal for pressure calibration systems in the U.S. and Canada. NPT Female adapters have a taper thread that wedges into the female NPT adapter. They seal due to the "out of roundness principle" which means that the Female stretches the female fitting until there is so much force that the connection can hold pressure. One of the challenges with this design is that if you connect stainless steel to stainless steel then over-tightening or poor lubrication can cause gauling and damage to the threads. Thread sealant is needed to seal but only 2 turns of thread sealant is required. Any more than that and the seal can leak around the thread sealant.