My ExportersIndia

For Buyer

For Seller

For Help

Our Products

  1. Testing Equipment 11 Products available
  2. Measuring Instruments & Equipment 6 Products available
  3. Electrical Cables & Wires 3 Products available
  4. Measuring Instruments 2 Products available
  5. Photography Equipment & Supplies 2 Products available
  6. Clamps 2 Products available
  7. Test Kits 2 Products available
  8. Earth Moving Vehicle 1 Products available
  9. Caps, Hats & Headwears 1 Products available
  10. Medical And Industrial Gases 1 Products available
  11. Insulators 1 Products available
  12. Electric Coil 1 Products available
  13. Generators 1 Products available
  14. Compass 1 Products available
  15. Filters 1 Products available
  16. Refractometer 1 Products available
  17. Medical Equipment & Supplies 1 Products available
  18. Laboratory Equipments 1 Products available
  19. Others Products 1 Products available

Analyzers And Analytical Instruments

Our product range contains a wide range of Three Phase Power Analyzer

Three Phase Power Analyzer

  • Frequency 40, 00…70, 00 Hz
  • AC voltage (TRMS) 0, 0…760, 0 V
Three phase power analyzer, Power quality analyzer PQM- 703 is a technically advanced product that allows for comprehensive measurements of the quality of electricity , analysis and recording of power network parameters, for frequencies 5060 Hz in accordance with European standard EN 50160. PQM -703 is another representative of a well, known family of analyzers line PQM- 70x . In relation to the PQM -702 has new functions like recording of transients with max. sampling frequency 10 MHz (rapid changes in voltage) and control signals. Minimal transient capturing time is 650 ns. It is intended for a very wide range of users who need to control the quality of power with a mobile device , which fulfills the requirements of a multi-sheet standard IEC 61000 for class A analyzers. This applies to measurement accuracy, measurement methods, and synchronization of time with a standard signal. The last condition is met with a built-in GPS module with an internal antenna. If the analyzer is installed inside, it is possible to use an additional antenna with a 10m-long wire. If the antenna is situated outside, GPS signal will be attainable without any problems and used for the synchronization of an internal clock.
View Complete Details
Tell Us What are you looking for? Will call you back

Contact Us