Suraj electronics Delhi

ADC0804 is an IC(integrated circuit) which converts the input analog voltage to its equivalent digital output. It is a stand alone analog to digital converter.

The LM2940 positive voltage regulator features the ability to source 1 A of output current with a dropout voltage of typically 0.5 V and a maximum of 1 V over .

TOPSwitch-HX cost effectively incorporates a 700 V power MOSFET, high voltage switched current source, PWM control, oscillator, thermal shutdown circuit, fault protection and other control circuitry onto a monolithic device. Product Highlights. Lower System Cost, Higher Design Flexibility.

The CD4001 is a part of the CD4000 IC series. CD4001 is a dual monostable multivibrator. Each device is retriggerable and resettable. Triggering can occur from either the rising or falling edge of an input pulse, resulting in an output pulse over a wide range of widths.

Available on stock Suraj electronics Delhi Deals all electronic components Import and export components All components are available Please contact All electronics components Suraj group Delhi & Mumbai

These 8-bit shift registers feature AND-gated serial inputs and an asynchronous clear (CLR) input. The gated serial (A and B) inputs permit complete control over incoming data; a low at either input inhibits entry of the new data and resets the first flip-flop to the low level at the next clock (CLK) pulse. A high-level input enables the other input, which then determines the state of the first flip-flop. Data at the serial inputs can be changed while CLK is high or low, provided the minimum set-up time requirements are met. Clocking occurs on the low-to-high-level transition of CLK.

74HC08 is Quad 2-Input AND Gate 14 Pin IC. The 74HC08 provides provides 4 independent 2-input AND gates with standard push-pull outputs. The device is designed for operation with a power supply range of 2.0V to 6.0V. It utilize advanced silicon-gate CMOS technology to achieve operating speeds similar to LS-TTL gates with the low power consumption of standard CMOS integrated circuits. The HC08 has buffered outputs, providing high noise immunity and the ability to drive 10 LS-TTL loads. The 74HC logic family is functionally as well as pin-out compatible with the standard 74LS logic family. All inputs are protected from damage due to static discharge by internal diode clamps to VCC and ground. Features:- 4 AND gates in a 14-Pin DIP Package Outputs Directly Interface to CMOS, NMOS and TTL Large Operating Voltage Range Wide Operating Conditions Specifications:- Type: DIP Bipolar Voltage Rating: 2.0 to 6.0V Temperature Rating: 0 to 70Deg C Number of: 14 Pins Mounting: Through Hole

The CD4052 analog multiplexers/demultiplexers are digitally controlled analog switches having low ON impedance and very low OFF leakage currents. Control of analog signals up to 15Vp-p can be achieved by digital signal amplitudes of 3 15V. For example, if VDD = 5V, VSS = 0V and VEE = 5V, analog signals from 5V to +5V can be controlled by digital inputs of 0 5V. The multiplexer circuits dissipate extremely low quiescent power over the full VDD VSS and VDD VEE supply voltage ranges, independent of the logic state of the control signals. When a logical 1 is present at the inhibit input terminal all channels are OFF CD4052 is a differential 4-channel multiplexer having two binary control inputs, A and B, and an inhibit input. The two binary input signals select 1 or 4 pairs of channels to be turned on and connect the differential analog inputs to the differential outputs. Features:- Wide range of digital and analog signal levels: digital 3 15V, analog to 15Vp-p Low ON resistance: 80 (typ.) over entire 15Vp-p signal-input range for VDD VEE = 15V High OFF resistance: channel leakage of 10 pA (typ.) at VDD VEE = 10V Logic level conversion for digital addressing signals of 3 15V (VDD VSS = 3 15V) to switch analog signals to 15 Vp-p (VDD VEE = 15V) Matched switch characteristics: RON = 5 (typ.) for VDD VEE = 15V Very low quiescent power dissipation under all digital-control input and supply conditions: 1 W (typ.) at VDD VSS = VDD VEE = 10V Binary address decoding on chip

BT134 Triac is a plannar passivated sensitive gate four quadrant triac in a SOT-82 plastic package. Its used in general purpose bidirectional switching and phase control applications. This triac is intended to be directly interfaced to microcontrollers, logic ICs and low power gate trigger circuits.

TIP41C Transistor NPN TO-220. 10pcs DIP Triode TIP42C/TIP41C PNP TO-220 Transistor Semiconductors Actives. Transistor x 10pcs Your selection.

The TIP31C is a base island technology NPN power transistor in TO-220 plastic package with better performances than the industry standard TIP31C that make this device suitable for audio, power linear and switching applications. The PNP type is TIP32C.

The BYQ28E-200E is a dual ultrafast Power Diode in a plastic package. It is rugged with a guaranteed electrostatic discharge voltage capability. It is suitable for use in output rectifiers in high-frequency switched-mode power supplies.

DESCRIPTION: The CENTRAL SEMICONDUCTOR 2N6027 and 2N6028 devices are silicon programmable unijunction transistors, manufactured in an epoxy molded package, designed for adjustable (programmable) characteristics such as Valley Current (IV), Peak Current (IP), and Intrinsic Standoff Ratio (). MARKING: FULL PART NUMBER.

The TIP31C is a base island technology NPN power transistor in TO-220 plastic package with better performances than the industry standard TIP31C that make this device suitable for audio, power linear and switching applications. The PNP type is TIP32C.20-Apr-2006

One of the leading Electrolytic Aluminium Capacitors manufacturers, catering to Europe and Asia Market. JWCO has been in forefront of capacitor business for .

Hunter Pacific capacitor 2.5 & 4.5 F for ceiling fan motors. 3 wire motor only capacitor to suit Hunter Pacific model ceiling fans

Suraj electronics Delhi Dealer all electronic components capacitor Ics MOSFETS connters Import and export components All requirement components Contact Suraj electronics Delhi.

Electrolytic capacitors must be used in circuits with the end marked positive always at a more positive potential than its negative end. Thus, they are normally used only where dc or pulsating dc voltages are present. Special types of non-polarized electrolytic capacitors are available for use in ac circuits.

Available on stock Suraj electronics Delhi Deals all electronic components Import and export components All components are available Please contact All electronics components Suraj group Delhi & Mumbai

The 6N135 and 6N136 are optocouplers with a GaAIAs infrared emitting diode, optically coupled with an integrated photo detector which consists of a photo diode and a high-speed transistor in a DIP-8 plastic package. Signals can be transmitted between two electrically separated circuits up to frequencies of 2 MHz.

We are ON SEMI, offering the MOC 3021M Optocoupler with DIP mounting type. This industrial-grade optocoupler features 6 pins and a minimum isolation voltage of 5300 VAC RMS. Perfect for manufacturers, this product ensures reliable performance. Made in India, this optocoupler is a top choice for your electronic projects. Trust ON SEMI for quality and performance in every component.

Miniature PCB mounted 200r top adjustable 1/4 inch single turn cermet trimmer potentiometer offering high stability and reliability which is fully sealed to .

10k Ohm 3590S Precision Multiturn Potentiometer is 10 rigs adjustable resistor. This is 10 turn potentiometer has a wire-wound variable technology that has a multi-turn POT of 10K ohm. This is 10k 3590S-2-103L is a precision potentiometer with a bushing mount, a fully sealed body, and PCB pins.

A trimpot or trimmer potentiometer is a small potentiometer which is used for adjustment, tuning and calibration in circuits. When they are used as a variable resistance (wired as a rheostat) they are called preset resistors.

A DC potentiometer is created by dropping voltage across a set of resistors in series. Different resistors will produce different values. In AC potentiometer, one can use resistors or even inductors or capacitors as impedances which will drop voltages and provide a voltage less than the applied voltage.

We offer high-quality Rotary Preset Potentiometers with a resistance range from 100 Ohms to 1 Megaohm, power rating of 0.1W to 2W, and a temperature coefficient of 50 Ppm/C. Ideal for precise control in various electronic applications. As a leading Manufacturer, we ensure reliable performance and durability in our products. Upgrade your electronic projects with our versatile Rotary Preset Potentiometers.

The AT89C51 is an age old 8-bit microcontroller from the Atmel family. It works with the popular 8051 architecture and hence is used by most beginners till date. It is a 40 pin IC package with 4Kb flash memory. It has four ports and all together provide 32 Programmable GPIO pins.

We offer the MUR460 Diode, a high-quality diode with a voltage rating of 600V and a current rating of 4A. The MUR460 model features a low forward voltage drop of 1.05V, making it efficient for various electronic applications. With dimensions of 5.2mm X 5.2mm X 2.5mm, this diode is compact and versatile. As a leading manufacturer, we ensure top-notch quality and performance in our products, meeting the needs of professionals and hobbyists alike.

The BP2329A is a high precision Active PFC controller for non-isolated buck offline constant current LED lighting. Operating in critical conduction mode, the controller achieves high power factor, low THD and high efficiency. After system powered up, the VCC pin capacitor is charged up by the start up resistor.

128x64 Character Graphic LCD has a display format of 128x64 dots and has yellow-green colour backlight. Each LCD needs a controller to execute its internal operations.

We are a leading manufacturer of high-quality Dial Type Thermometers, proudly made in India. Our thermometers feature advanced technology with Atmel 89S52 for precise temperature readings. With a compact size and durable design, our thermometers are perfect for various applications. Trust our reliable products for accurate temperature monitoring in any setting. Choose our Dial Type Thermometer for superior performance and quality assurance.

A Industrial Electronic Buzzers or beeper is an audio signalling device, which may be mechanical, electromechanical, or piezoelectric.

MCT2E is a phototransistor Optocoupler, as the name phototransistor suggests it has a transistor which is controlled based on light (photon). So this IC basically has an IR (infrared) LED and a photo-transistor inside it. When the IR led is powered the light from it falls on the transistor and it conducts.

We are CDIL, a leading manufacturer offering the CL100 Power Transistor. This PNP transistor, part number CL100S, features a voltage rating of 50V and a current rating of 4V. With a DIP mounting type, this transistor is ideal for various electronic applications requiring reliable performance and efficiency. Trust CDIL for high-quality components that meet your electronic needs with precision and durability.

A seven segment, 7 segment display is the most basic electronic display device that can display digits from 0-9. They find wide application in devices that display numeric information like digital clocks, radio, microwave ovens, electronic meters etc. High Intensity Output.

The LM35D device is available in an 8-lead surface-mount small-outline package and a plastic TO-220 package. The LM35 series are precision integrated-circuit temperature devices with an output voltage linearly-proportional to the Centigrade temperature.

State Electronics is a leading manufacturer of custom and standard potentiometers. The Potentiometer Specialists - With Satisfied Customers Around The World.

A seven-segment LED is a digital display module specialized to display numerical information. Light-emitting diodes (LEDs) arranged in the shape of numbers offer an easily visible display. They are sometimes called "seven-segment displays" or "seven-segment indicators."

This 32.768 kHz model comes in a cylindrical style standard package and is breadboard friendly and easy to use with any microcontroller, RTC, or device that requires an external crystal. The crystal has 20pF load capacitance requirements and is ideal for use when you have a real-time clock or other ultra-power chip.

The KBPC3510 is a single-phase Bridge Rectifier with diffused junction and metal case. Low Power Loss and High Efficiency. Electrically Isolated Metal Case for Maximum Heat Dissipation. Through Hole with #10 Screw Mounting. Case to Terminal Isolation Voltage of 2500V.

Description. The MOC3081M, MOC3082M and MOC3083M devices consist of a GaAs infrared emitting diode optically coupled to a monolithic silicon detector performing the function of a zero voltage crossing bilateral triac driver.

The 33883 is an H-bridge gate driver (also known as a full-bridge pre-driver) IC with integrated charge pump and independent high and low side gate driver .

We offer an SEO-friendly Microcontroller with an 8-bit architecture, capable of speeds up to 100 MHz. Our product is designed to operate in a temperature range of -40C to 85C, making it ideal for various applications. As a leading manufacturer, we provide high-quality Microchip Microcontrollers that deliver reliable performance and efficiency for your projects.

The WWF series wire wound fusible resistors are manufactured to perform as a regular resistor under normal conditions and as a fuse under excessive load. In WWF series, resistors up to 5W, the resistance value is colour coded with 3 bands plus a tolerance band.

Suraj electronics Delhi Dealer all electronic components capacitor Ics MOSFETS connters Import and export components All requirement components Contact Suraj electronics Delhi

We are a leading manufacturer offering the HB 1N5408 Rectifier Diode, ideal for electronics applications. This Through Hole diode has a voltage rating of 1000V, ensuring reliable performance. The part number 1N5408 signifies its quality and compatibility. Trust our product for efficient power rectification in your electronic projects.

The IN4007 diode is a device which allows current flow through only one direction. That is the current should always flow from the Anode to cathode. For 1N4007 Diode, the maximum current carrying capacity is 1A it withstand peaks up to 30A. Hence we can use this in circuits that are designed for less than 1A. The reverse current is 5uA which is negligible. The power dissipation of this diode is 3W.

The AMS1117 series of adjustable and fixed voltage regulators are designed to provide up to1A output current and to operate. down to 1V input-to-output differential. The dropout voltage of the device is guaranteed maximum 1.3V, decreasing at lower load currents. On-chip trimming adjusts the reference voltage to 1.5%.

The LM117 and LM317-N series of adjustable 3-pin positive voltage regulators are capable of supplying in excess of 1.5 A over a 1.25-V to 37-V output range and a wide temperature range. They are exceptionally easy to use and require only two external resistors to set the output voltage.