SV Technologies

Hasthinapuram, Chennai, Tamil Nadu

introduction of plastic pellet/flakes drying machine
1. this machine is mainly used to dewater granular / flake plastic material by high speed rotating blades.
2. stable operation with low noise and high working efficiency.
3. used for recycling plastic flakes/pellets/chips, chopped scrap dewater;
features:
the machine consists of the following main parts: spindle, spindle motor, discharge port, rotor blade, inner stainless steel screen, outer cover, electric box, feed hopper, feeding motor, reduction box, feed screw.
1. the eighth generation plastic pellet dewatering machine uses the advanced vertical dewatering machine structure, which is highly efficient in dewatering, saves electricity, and is more convenient for sewage recovery;
2. the internal blades of the dewatering machine are all simulated by computer. the blade distribution and angle are scientific and reasonable, the cutting force is high, and the contact with the material is small. it can ensure the smoothness and integrity of the material, and it will not cause damage or loss to the plastic particles. the limit improves the working efficiency of the dehydrator;
3. the main shaft adopts a solid imported alloy steel column, which is never deformed, wear-resistant, acid and alkali resistant;
4. the left and right side doors adopt double-slot base, no sewage overflows to ensure the workshop is clean and convenient for mechanical sewage recovery;

Features:

All material contact surfaces are made of stainless steel to avoid material contaminationPrecise aluminium casting hopper barrel features smooth surface & good performance on temperature keepingSilent fan, optional wind filter, to ensure that raw materials from pollutionHopper barrel is fitted with see-through windows to observe inside material levelHopper barrel separated from its base for easy cleaning

FEATURES

1. Using the high performance of the uniform dispersion of hot air diffusion device, keep the plastic dry temperature, increase the drying efficiency.2. The unique hot air duct design, can avoid powder accumulation in the bottom of the electric heating pipe, causing combustion.3. The barrel and internal parts are all made of stainless steel.4. Barrel and bottom of separation, easy to clean material, refueling quickly.5. Using the proportional deviation indicator temperature controller, can accurately control the temperature.6. There is a double overheating protection device, can reduce the man-made or mechanical failure caused by the accident.7. A variety of models can provide pre heating timing device, microcomputer control, and double layer insulation material barrel selection.8. All digital LED control P.I.D status display.9. 0-99 hours automatically boot time.10. Provide intermittent drying mode, in order to achieve the purpose of saving electricity. (SHD-DT only with 8-10 Series)11. Transparent window type magnet base.