Write a Review
Our Products
We offer a complete product range of GPS Module Patch Antenna and External Active Antenna
Product ID: 1133 The GPS Module Board NEO-6MV2 is the easiest and best GPS module you can add to your project. It includes the GPS antenna and the ublox GPS receiver module. Connect the 4 communication pins (VCC, GND, TX, RX) directly to your Arduino or any microcontroller, run the example library below and start getting GPS location data's in minutes. Check out the linked library to get the most out of this GPS and add it to your project very easily. U-blox/u-blox NEO-6M GPS module with antenna and build-in EEPROM This module is compatible with APM2 and APM2.5, and EEPROM can save all your configuration data. Interface: RS232 TTL Power: 3-5v Baud rate default: 9600bps
Product ID: 1257 GPS receiver module high sensitivity GPS module:-165dBm low power consumption small size support walk model The Skylab SKG13 series is a complete GPS receiver module that features super sensitivity, ultra low power and small form factor. The GPS signal is applied to the antenna input of module, and a complete serial data message with position, velocity and time information is presented at the serial interface with NMEA protocol or custom protocol. It is based on the high performance features of the MediaTek 3329 single-chip architecture, Its -165dBm tracking sensitivity extends positioning coverage into place like urban canyons and dense foliage environment where the GPS was not possible before. The small form factor and low power consumption make the module easy to integrate into portable device like PNDs, mobile phones, cameras and vehicle navigation systems. Dual Power Source, Serial and TTL output Free GPS Active Antenna.
Tech-Graylogix (Tech-Graylogix)
5th floor, Oberle Towers, Balmatta, - 575002., Mangalore, Karnataka, India
Share us via
