Thirumala Makers & Marketers

Nungambakkam, Chennai, Tamil Nadu

Band knives are a flat length of narrow steel you would mount onto a band-style cutting machine to slice, slit, or score material. A band knifes cutting edge is designed to slice through material leaving minimal waste in the process.Band Knife blades are used on two types of machine (vertical and horizontal) depending on the material being cut.
On a vertical band knife machine usually a narrow width band knife blade is used, the most common width being 10 mm. The length of the band knife blade depends on the supplier of the band knife machine. The dimensions are indicated on a small metal tag pasted or riveted on the machine. The vertical machine band knife blade is most commonly a "double bevel, double edge DBDE" execution to enable cutting while advancing the table and also while retracting the work table, while as the "double bevel, single edge DBSE" execution cuts only in one direction. Productivity is enhanced when the operator cuts both while advancing and also while retracting the work table after adjusting the foam block after each pass for cutting. The DBDE execution blade can have a parallel or twisted 180 degrees welding. The twisted welding execution saves a grinding unit, as both edges pass the same grinding unit after two turns. It has been observed that a narrow width on a vertical band knife machine gives better dimensional accuracies on the foam block. The wider the vertical machine band knife - more the deflection and size variation from one end to the other extreme end.
Horizontal band knife blades are wider usually 30-60 mm wide for foam converting is popular, for leather goods 40-50 mm wide blade is popular, 85-110 mm width is popular for the tannery splitting band knife. There are other widths depending on the machine manufacturer. The horizontal machine band knife blade is supported by a guide to give dimensional accuracies while cutting/splitting. Therefore, only blades that have passed as one main manufacturing step a surface grinding process reach the necessary thickness tolerances of less than 0.02 mm. A higher tolerance would lead to marks on the surface of the split material like leather or rubber. Blades are available in different grades of exactness depending on the required exactness on the material to be cut/split. On modern machines in combination with a high grade blade a splitting thickness of 0.2 mm for 1500 mm material width is possible.