Write a Review
Our Products
Our Complete range of products are Flow Table Motorised, Vibrating Tables and Flow Table Electrically Operated.
The Flow Table top is 76.2 cm dia, finely machined from a solid brass casting. The integrally cast ribs are designed for support and strength. The stand is fabricated of cast iron and is of sturdy construction. Holes for mounting on foundations are drilled in the base plate. The ground and hardened steel cam is designed to drop the table by 12.5 mm with an electric geared motor.The equipment is supplied along with flow mould.suitable for operation with 220 volts, 50 Hz, single phase, AC Supply.
ApplicationFlow Test Measurement
Industry| Cement/RMC | Construction Chemicals |
| Dams & Tunnels | Fly Ash |
| Irrigation | Railways Sleepers |
| Real Estate | Refractories |
| Roads, Highways & Bridges |
| Architecture | Building Technology |
| Civil Department | Geotechnical |
| Science Colleges |
| Tiles & Ceramics |
| Fly Ash |
| Railways | Roads, Highways & Bridges |
Proper compaction of cement concrete while casting specimens for compression testing is essential to achieve higher compressive strength.AIMIL Vibrating Table is ideally suited for this purpose. The table top is suitable to hold cube moulds and has stops along its edges to prevent moulds from sliding off the table during operation.The specially designed vibro motor for operating the vibretor.Suitable for operation on 220 V, 50 Hz, Single Phase, AC supply.
ApplicationVibratory Compaction
Industry| Cement/RMC | Construction Chemicals |
| Dams & Tunnels | Fly Ash |
| Irrigation | Railways Sleepers |
| Real Estate | Refractories |
| Roads, Highways & Bridges |
| Architecture | Building Technology |
| Civil Department | Geotechnical |
| Science Colleges |
| Tiles & Ceramics |
| Fly Ash |
| Railways | Roads, Highways & Bridges |
The Flow Table consists of a brass table top 250 2.5 mm dia, mounted on a rigid stand. The table top is reinforced with equally spaced ribs and allowed to drop through 12mm by a ground and hardened cam. The Motor Drive assembly using the geared motor box is designed to rotate the cam through the shaft at 100 rpm.
ApplicationSample preparation
Industry| Cement/RMC | Construction Chemicals |
| Dams & Tunnels | Fly Ash |
| Railways Sleepers | Real Estate |
| Refractories | Roads, Highways & Bridges |
| Tiles |
| Architecture | Building Technology |
| Civil Department | Geotechnical |
| Science Colleges |
| Tiles & Ceramics |
| Fly Ash |
| Railways | Roads, Highways & Bridges |
TIRTH ENTERPRISE (TIRTH ENTERPRISE)
A/21, Aarushi Bunglows,
Opp. Sharan Residency,
Nr. Shefali Jain Temple,
Vasna, Ahmedabad - 380007, Gujarat
Share us via
