Trade Tracks

We are offering plate heat exchangers. Plate heat exchanger comprises of corrugated thin titanium or ss plates which are sealed by integrally fitted gaskets. These gaskets act as reliable seals between the plates nd create alternative flow channels where hot fluid circulates on one side and cold fluid on the other hence maximizing the heat transfer surface. The plates are held together in compression by long threaded studs on the outside of the tube bundle that pass through the end covers to which they are fixed by using spring washers and nuts. There are also plate carriers fitted to the top of the bundles that align the plates at assembly of the tube bundles.

Investment Casting is one of the oldest manufacturing processes. In this process, a wax pattern is created using a stereo lithography or similar computer modelling techniques. This wax pattern is dipped or “invested” into refractory slurry, which coats the wax pattern and forms a mould. This is dried and the process of dipping in the slurry and drying is repeated until a robust thickness is achieved. After this, the entire pattern is placed in an oven and the wax is melted away. Investment casting is often referred to as "lost-wax casting" because the wax pattern is melted out of the mold after it has been formed.

We offer mechanical pump seals. Mechanical seals are designed to prevent leakage between a rotating shaft and its housing under conditions of extreme pressure, shaft speed and temperature. All seals are designed and qualified tested according to the stringent testing norms. These dependable, engineered mechanical seals are developed to attain extremely low emmissions, typically to less than 150ppm. They can be single acting or double acting.

We offer Crankshaft. Crankshaft is a component which converts the up and down movement of the pistons of the cylinder into continuous rotary motion which is transmitted further to move the propeller shaft in case of marine diesel engines. The Crankshaft of the Marine Diesel Engine acts as the outlet of power from the engine for supply to the huge propeller immersed in the sea which helps to propel the ship.

We offer Turbochargers. Turbochargers are provided with the engine to use the exhaust gases in order to supply a consistent flow of fresh air inside the main engine. A turbocharger is basically a combination of a compressor and a turbine, both mounted on a common shaft. Turbocharger uses the exhaust gases of the engine itself, to rotate the turbine which in turn moves the compressor.

We offer Fresh Water Generators. Fresh water generators are used to generate fresh water on ship and is also known as an evaporator. The process by which fresh water is generated is known as distillation process. Sea water is converted into fresh water by evaporation and condensation process. Evaporation of the sea water is either done by boiling or by flash process.

We are offering S.S Centrifugal Pumps.

We are offering FRP Spares.

We are offering Cream Seperator Spares.

We are offering S.S Fittings.