This is the simplest Basic water level Controller with indicator it is the most economical and energy efficient product from RGR Technologies.

Visual Indications : Two sump levels, Two over head tank indication. Flow, motor on, dry run, power on.
Features: The water level controller can switch on or switch off the pump, to maintain the pre defined water level at the storage tanks.

Low AC Voltage sensing circuit to avoid polarization of electrodes in water. These special stainless steel plastic molded conductive electrodes are Long life sensors and do not require frequent cleaning or replacement.

Its has the following unique feature:
1) When tank is in reserve mode or empty it automatically starts the motors if water is present in the Sump tank.
2) If water is present in the line it indicates the presence on the unit (Flow Indicator).
3) It indicates water levels reaching in tank, which is helpful if there are open taps, blockage, leakage or damage in the pipeline connected to the upper head, ground or the desired storage tank.
4) It green colored 2 level indications (half tank & full tank) of water in tank as well as 2 level indications (foot valve level & half tank) of sump tank.
5) On motor symbol green colored indication for motor ON & red colored indication for dry run of motor.
6) Has rocker switch to select Auto/manual operation.
7) Has soft touch NEED button to switch ON the motor irrespective of any level in the overhead tank.

Application:

mono block pumps (sump motors)
System is suitable only for single phase pump sets of maximum 1 H. P. ratings.

This Water level controllers Indicator is highly recommended for metro cities or areas where drinking water is supplied through pipelines which are further distributed in homes, hotels, societies etc.

At large our systems not only help you but your neighbors and society, also as it reduces the wastage of water by cutting down any further overflow than what you need.

The Sri Digitek water level controller ULDX-01 is a high performance system, built compactly to provide advanced features like clear liquid level display, auto / manual MODE selection soft switches, in-built low and high voltage cut-off, surge protection, dry run protection and easy operation. The water level controller can switch on or switch off the pump, to maintain the predefined water level at the storage tanks. Sri Digitek Automatic Water Level Controller ULDX-01 can control motors up to 2 Hp capacity directly (with- out starter).
Suitable For Mono Block Pumps, Sump Submersible Pumps, Jet Pumps, Centrifugal Pumps, .Etc.
Application Like Residential Buildings, apartments, Commercial Complexes, Industrial Buildings, Hotels, Hospitals, . . . .Etc

FEATURES
High reliability and Low maintenance.
Automatic Water Level Controller ULDX-01 can be used for a long time, no maintenance or repairing would be Required during its operational period.
Low AC Voltage sensing circuit to avoid polarization of electrodes in water. These special stainless steel plastic molded conductive electrodes are Long life sensors and do not require frequent cleaning or replacement.

Overflow prevention system provides effective and reliable Water level monitoring, with Level Indicators.
Visual Indications : Four stage water level indicator for over head tank, three stage water level indicator for the sump, water flow indication, voltage level indication, power on indication and auto/manual indication.
How It Works : Automatically starts the motor when the water level in the over head tank drops below a pre-defined level (normally 50%) and switches off the motor at tank full or the sump water level drops below foot valve level.
Dry Run
Due to faulty foot valve or air leakage in the pipe if the motor runs dry then it gets switched off automatically and gives fault indication. For more details please watch video demo.
Voltage Cut-off
Automatic Water Level Controller ULDX-01 automatically switches-off the pump if the supply voltage drops below 160V or Crosses 250V.

Surge protection

Built in surge protection is the Main featurese of ultradeluxe series.
Soft Switch auto / Manual
Automatic Water Level Controller ULDX-01 comes with this feature of selecting manual/auto mode as per the requirement by just pressing the respective soft switch.
Manual mode is used to Draw the water directly from the pump for activities like car wash, front area wash, tank cleaning, watering the plants Etc.
Need
The Optional Need soft switch is provided to Switch on the motor irrespective of the water level in over head tank.

Rocker Bypass Switch.

The optional rocker switch is provided to bypass system operation in case of system failure. so no need to disconnect the system when it gets failed.

Power ON/OFF Switch.

Has rocker switch to select Power On/Off operation.
The Special Feature

Automatic Water Level Controller ULDX-01 shifts from Manual Mode to Auto Mode automatically if the over head tank gets filled. The system changes the mode automatically.

In Ultra deluxe series varients are avilable for any type of pump, bore well and any combination of tanks.

Application: The product is suitable for almost all site conditions water tank for maintaining level automatically, can be used to control water inflow or outflow, by means of direct pump control or acting as a control switch of a magnetic or combination stater.

Sutable for

mono block pump (sump motor)
sump submersible pumps.
Jet Pumps, etc.

This Water level controllers Indicator is highly recommended for metro cities or areas where drinking water is supplied through pipelines which are further distributed in homes, hotels, societies etc.
At large our systems not only help you but your neighbors and society, also as it reduces the wastage of water by cutting down any further overflow than what you need.

Automatic Water Level Controller For Single Phase Submersible Pumps Panel Driver (Single phase to three phase). This is a unique device for submersible Pump Up to 2.5 HP Capacity. Our submersible panel drive is the most suitable device for start/Run capacitors Panel Driven Water Pumps. It increases the life of motor to work for year. Application Like Residential Buildings, apartments, Commercial Complexes, Industrial Buildings, Hotels, Hospitals, . . . .Etc.

Visual Indications :

Four stage water level indicator for over head tank, water flow indication(Running Line), voltage level indication, power on indication and auto/manual indication.

Features: Switch on the panel if water tank is in required mode and switch off the panel at tank full.
This is a product mainly focused to help people with submersible pumps who previously had little control over the functionality of the pump and had to start manually and stop the pump with all those uneasy methods. which make the operation of these pump difficult for novice users, keeping in mind the ease of use we developed this system which makes the operation of these pumps a child's play.
It is an unique device for single phase submersible pumps.

Low AC Voltage sensing circuit to avoid polarization of electrodes in water. These special stainless steel plastic molded conductive electrodes are Long life sensors and do not require frequent cleaning or replacement.

How It Works : Automatically starts the motor when the water level in the over head tank drops below a pre-defined level (normally 50%) and switches off the motor at tank full or the sump water level drops below foot valve level.
Dry Run
Due to faulty foot valve or air leakage in the pipe if the motor runs dry then it gets switched off automatically and gives fault indication. For more details please watch video demo.
Voltage Cut-off
Automatic Water Level Controller ULDX-DR-1ph automatically switches-off the pump if the supply voltage drops below 160V or Crosses 250V.

Surge protection

Built in surge protection is the Main featurese of ultradeluxe series.
Soft Switch auto / Manual
Automatic Water Level Controller ULDX-DR-1ph comes with this feature of selecting manual/auto mode as per the requirement by just pressing the respective soft switch.

Manual mode is used to Draw the water directly from the pump for activities like car wash, front area wash, tank cleaning, watering the plants Etc.

Need

The Optional Need soft switch is provided to Switch on the motor irrespective of the water level in over head tank.

Rocker Bypass Switch.

The optional rocker switch is provided to bypass system operation in case of system failure. so no need to disconnect the system when it gets failed.

Power ON/OFF Switch.

Has rocker switch to select Power On/Off operation.

The Special Feature

Automatic Water Level Controller ULDX-DR-1ph shifts from Manual Mode to Auto Mode automatically if the over head tank gets filled. The system changes the mode automatically.

Application:

The product is suitable for almost all site conditions water tank for maintaining level automatically, can be used to control water inflow or outflow, by means of direct pump control or acting as a control switch of a magnetic or combination stater.

Sutable for

Bore well submersible pumps.
Jet Pumps,

In Ultra deluxe series varients are avilable for any type of pump, bore well and any combination of tanks.