Uni4 Embedded Technologies LLP

Handewadi Road, Pune, Maharashtra

• Detects temperature and outputs digital and analog signal. The digital signal can have a trigger level.
• LEDs indicate power and output signal. Using the NTC thermistor sensor
• Compatible with Arduino and Raspberry boards, Operating Voltage: 3.3V to 5V DC
• Output Digital - 0V or 5V, Adjustable trigger level from preset, Output Analog - 0V to 5V based on temperature on ambience
• A small PCB board size: 3.4 x 1.4cm,

• 6 PIN
• Push to Insert and Push again to Eject
• Used for Micro SIM
• Drawing will be send by email or hardcopy
• Price for 10 pieces

• Do not buy for OTHER phones not even for normal LANDLINE as well, Please message us if you are looking for any other phone,
• RJ9 plug connect to Polycom phone and 3.5mm female jack to connect headset
• Avoid having to purchase an expensive wired/wireless headsets , Use your existing wired headset
• NOT COMPATIBLE with iPhone headset, Please send message to us if you need such

• Push to Insert and Push again to Eject
• PCB Mount
• Drawing will be send by email or hardcopy
• Price for 10 pieces

• A small, high-quality, quad-band, common-used, standard SMA (internal male pin), cellular GSM antenna.
• GSM : 880 to 960MHz, 1710 to 1880MHz
• Total Length is around 5CM
• 2Dbi, 50ohm, 50W,

Give your GPS module a boost with this external active antenna. This GPS antenna draws about 10mA and will give you an additional 28 dB of gain. It's got a 5 meter long cable so it will easily reach wherever you need it to. The antenna is magnetic so it will stick to the top of a car or truck (or any other steel structure) Comes with a standard SMA connector on the end to connect GPS module. GPS not included.

• Magnet mount antenna for GPS modules
• SMA Male connector
• Operating at 3 V to 5 V.
• 3 Meter cable

You can refer to your GPS module datasheet on how to connect to your GPS module. Normally its just 2 wires. one is ground and second is RF-IN(Center Pin of SMA) which also gives power to antenna.

• Universal Input Voltage: 100v-300v AC 50/60Hz
• Dual Output Pin: DC Pin + Sony Pin
• Short Circuit & Overload Protection
• Stabilized Output, Low Ripple & Low Interference
• Please check power rating before purchase

• This is an USB 2.0 to TTL UART Converter module which is based on CH340G IC
• This module used with Laptop's which don't have standard serial port. This module creates a virtual COM port using USB on your computer which can support various standard Baud Rates for serial communication
• Target board +5v and +3.3v power supply selection upto 200 mA current consumption
• All handshaking and modem interface signals like RTS, CTS, DTR, DCD, DSR, RI along with Rx and Tx
• Onboard 500mA overcurrent protection resettable fuse