Automotive Brakes #4284005

Hydraulically Released Spring Applied Brakes
There is a variety of possibilities to use hydraulically released spring-applied multi-disc brakes in the stationary and mobile sector, also combined with hydraulic motors. The brakes can be integrated in the oil circuit of the motor. When starting the hydraulic motors, the brakes release with oil pressures of 15 to 38 bar. Thereafter the full system pressure up to 320 bar can be connected. The brakes can be used in wet and dry operation. With failure of the oil pump, an emergency release is possible.

Pneumatically released spring-applied multi-disc brakes with or without pneumatic motor are used in all sectors of engineering. The brakes release from 5 bar. Thereafter the system pressure of 10 bar may be connected. Application in wet and dry operation possible. Torques from 30 to 13000 Nm (higher torques on request), Air pressure for release from 5 bar, thereafter the system pressure of 10 bar may be connected, Application in wet or dry operation possible, Outer diameter 105 to 710 mm

Spring-applied. Operated via a special control unit for connection to A.C. When providing 1 brake calliper to the brake disc only, pertinent reaction force as radial force on the horizontal shaft to be braked - other mounting positions on request. When providing 2 brake callipers at 180 degrees apart, no reaction force. Less maintenance - simple handling Torques from 105Nm to 25000 Nm Brake disc outer diameters from 250 to 2000 mm Dry operation Smallest assembly space Highest heat capacity Strong construction