SPOT-WELDED : Design is similar to that of the built-in barrel nut. Made of an independent strap fastener that is spot welded to the top sheet on each side of the gap. This type of clamping mechanism is used to accommodate a heated section below the fastener.
INDEPENDENT STRAP : Straps are tightly clamped around the cylinder's surface and distribute the drawing force uniformly around the band heater. This force is transferred to the inside windings and improves heat transfer by providing effective surface contact and elimina
FLANGE LOCK-UP : The most economical clamping mechanism. Designed for narrow heaters.
BUILT-IN : Same features as the independent strap. The top sheet is made into a strap by placing barrel nut fasteners on either side of the gap. Barrel nuts are used for holes and cutouts, as an alternative to independent straps
WEDGE LOCK : Basic design for limited space above the heater. Composed of clamp slides (wedge shape) on the lips of the heater on either side of the gap. Standard height between the inner diameter and the highest point of the wedge lock is 5/16”
A mica core produces a thin, efficient heater. Heat from the precisely wound element is quickly transferred to the working surface for expedited heat up. Mica provides optimum dielectric strength and heat transfer capabilities for an extended heater life. The mica core is...
The MI band heater from Watlow® is a high-performance heater. Its performance and name are derived from Watlow’s exclusive mineral insulation - a material with much higher thermal conductivity than mica and hard ceramic insulators used in...
Nozzle band heaters by Thermal Corp; HotNoz™, last more than seventeen times longer than the best competitor units tested and can operate at over ninety watts per square inch....
New XT Performance – The next generation of excellence in Heater performance and quality. The XT band provides for higher temperature performance, complete design flexibility and improves energy efficiency all at a lower cost than Mineral...
The Hotwatt Standard Band Heaters are manufactured in one or two piece constructions with maximum inside diameters of 11 12" and 22 12" respectively. Three or more sections are employed when heaters of larger diameters are needed (as for blown film...
Mi-PlusTM is a mineral insulated band heater designed for applications that require high watt density andor high operating temperatures. Mi-Plus band heater has a thin low profile cross section using all stainless steel sheath material. The clamping...
Tutco offers a variety of band heaters to accommodate any cylindrical application. Tutco's product offering ranges from the HT Mica Band using high temperature mica and sheath materials for your high temperature applications, to the better belly...
Related Products
For Buyer 
For Seller 
Help 
