Daco Precision - Tool

Progressive Die Stamping is the process to modifying the raw material through a series of punch press cycles and the re-positioning of the raw material. You may see one or multiple processes combined to produce a finished part such as; Punching, Bending, Coining and Drawing or Tapping of the raw material. These processes; when performed in multiple operations or cycles of the press will produce a finished part through the progressive dietool, saving youre the expense of set-up time, and reduces the overall labor and production costs. Here at DACO Precision-Tool its our goal to design and build our progressive dies to exceed 100 strokes per minute to support high volume production. We can achieve this by building in sensors and other accessories to protect the die from damage. Cycle time is always kept in mind when designing and building our progressive die tooling. Parts are produced when the feed system pushes (strip or bulk coils) of raw material into the feed port of the progressive die tool; at each stroke or cycle of the press until the finished part is produced out the other end of the tooling. The feed rate of the material is controlled by the hard stops in each die section and the sensors built into the tooling. The final die section regardless of the number of tooldie sections required to produce a finished part; performs the cut-off operation. This separates the finished part from the carrying web; allowing the finished part to falls into the parts collection bin. The carrying web and material removed during the prior stages are conveyed to the scrap shoot and dropped into the scrap collection system. Use the Request Information selection to contact us and provide your design documentation with your contact information for our Engineering Department to review and provide you with a quote. Or if you have tooling that isnt running right, or as quickly as you need or desire; let DACO Precision-Tool troubleshoot, modify, and repair existing tooling to get it up and running to a higher production rate for you

DACO can design and build bending and forming tools, usually considered a secondary operation where a flat blank or part is placed into the tool and formed and bent with one or more operation or single press cycle, Usually lower volume parts will be formed and produced from secondary bending and forming tools. BendForm Dies are used to bend, form, or draw the material or part into a variety of angles and shapes. This can be done as a secondary tool and operation, or it can be built into a progressive die. DACO Precision-Tool uses a variety of 2D and 3D cadcam Software to develop, design, and plan the layout of our dies. (see below for the full software list & details). We have the resources to build a die for any application. When high volumes of production are expected, we can build a dependable tool with longevity in mind. We can also produce low-cost tools for prototyping and sampling applications. Die protection is always on our mind, and DACO Precision-Tool can build in sensors that will help prevent costly damage to the die. Do you have a tooldie that isnt running right, or as quickly as you need? DACO Precision-Tool can troubleshoot, modify, and repair existing tooling to get it up and running like you need it to. Use the Request Information selection to contact us. Attach your design documentation along with your contact information for our Engineering Department to review and provide you with a quote.