We manufactured the Brass threaded inserts highlighted here for an infusion disintegrate that was delivering an over shaped part for a car industry application. This venture exhibits our capacity to make complicated components at high throughput...
E-Z LOK external threads are standard size and pitch to permit use of standard drills and taps. No special tap sizes or installation tools are required. E-Z LOK inserts will not back out or vibrate loose. Immediately upon installation,...
Spring plunger in small design with internal damping spring for handling of workpieces with differing heights and curvatures Handling of very sensitive workpieces (e.g. printed circuit boards) without additional control expenses; ensures gentle...
KATO CoilThread inserts are based on a continuous helically-coiled open pitch design using a diamond shaped wire. The diamond-shaped wire design allows the inserts to engage the threads in the parent material and at the same time accept a male...
Delrin body plungers have bottom end slot only. Delrin has high strength with good wear resistance. Delrin body has a limited high temperature stability - 180 degrees F. Click here for our special plunger quotation request form....
With our expertise for manufacturing small, thin gauge stamped parts with precise dimensional tolerances, American Industrial Company was contracted to produce the brass inserts shown here for a customer in the plastics industry. From die design and...
Related Products
For Buyer 
For Seller 
Help 
