Xinxiang Great Wall Machinery

Zhengzhou, United States

Material will be feed into kiln tail through chute in gas chamber. As kiln shell is inclined and it rotates slightly, material will move along round shell and will also move along shaft direction from kiln tail to kiln head. Material will be processed through pre-heat, decompose, calcined and will be feed intocooler. Fuel will be given through gas or coal burner at kiln head and will be combusted in kiln. Heat will be transferred to material by fire radiate, hot air flow, kiln brick transfer. The heat will heat and calcine material enough and make it final product.

1. Simple operation, large output

Lime rotary kiln can easily and flexibly adjust the yield and quality. Its operation is smooth and the failure rate is low, can improve the work efficiency and production.it can be used in 50-1500TPDactive lime production line.

2.Calcined raw material diameter

Cement rotary kiln, as the main equipment ofdry cement clinker production line, is the most efficient cement calcination equipment. CHAENG cement rotary kiln can meet 300-5000 t/d cement production line construction requirements, with simple operation, high production production, smooth operation.

In appearance, the kiln body is inclined to a certain level. The whole kiln body is supported by supporting roller and equipped with thrust roller to prevent it from moving up and down. In addition to the main drive, the transmission system is also provided with an auxiliary driving device which can still rotate the kiln body and prevent the bending of the kiln body when the in the main power supply is off. The material is fed into the upper end of the air cylinder. As the cement kiln rotates, the materials gradually move towards the lower end, and they may go a certain amount of stirring and mixing. Hot gas goes through the rotary kiln, in the same direction with the processed materials, but usually in the opposite direction. The hot gas may be generated in an external furnace, or may be generated by flames inside the kiln. They are repetitively scattered in the air so that they are in full contact with the hot air, the materials are dried gradually)

The kiln head and kiln end adopts advanced sealing technology to ensure the reliability of the seal.

CHAENG new dry cement rotary kiln is currently the most reasonable investment in a rotary kiln equipment. Compared with the traditional wet rotary kiln, it is the best for cost saving and pollution reduction in cement production industry in the world.