Other Products / Services #4405380

Automatic rotary sprinkler system made of Aluminum alloy or cast steel material, with rotary head and sprinkler pipe distributes the hot water over the entire space of the filler. Sprinkler pipes are non-clogging, require low pressure to operate and assures uniform water flow with minimal operating pump head. The FRP eliminators attached to sprinkler pipe are specifically designed for low pressure drop and minimizes the drift loss of water.

For FRP Cooling Towers: The fill is of rigid Polyvinyl Chloride (PVC) and is of honeycomb design with very large contact surface area. The fill splits the air and water into several streams, increasing the time of contact and also heat transfer between water and air. The fill is in modules and is packed in the tower casing without ant cutting for curves. The air pressure drop through the fill is negligible. The fills are available with flute height of 12mm and 19mm with sheet thickness of 0.15 mm and 0.20 mm . For Timber Cooling Towers: Our cooling towers are fitted with Foster Wheelers stack type fill arrangement, comprising of splash bars fixed with transverse stringers making the fills into removable trays. This arrangement makes an excess to wet surface area and eliminates any chances of fill collapse. The splash bars and trays are made from As-Cu treated pinewood and are rectangular in cross-section.

Cooling towers are fitted with FRP Axial Flow Fans with Aerodynamic efficiency and significant saving in higher operating cost. Fan Blades are made up of fibre glass reinforced epoxy resins. These blades are hollow in construction and have been designed with most efficient aero foil section.

The motors are totally enclosed (IP55), Flange type , 420 V, 3 ph, 50 Hz., induction weather proof with extended shaft and are specially designed for cooling tower application. Fans are directly driven by electric motors in small models and coupled through gearbox in larger models subject to the tip speed of the fan.