Our Products
Our Complete range of products are Beam Moulds, Le Chatelier Molds, Cylinder Moulds and Cube Moulds.
For making cement concrete prisms or bars of square cross section for flexural strength test. Faces are machined flat to within 0.02mm and inside dimensions to 0.2 mm made of Cast Iron or Steel, supplied complete with base plate.
Size:
40 mm x 40 mm x 160 mm made of Cast Iron.
100 mm x 100 mm x 500 mm made of Cast Iron.
150 mm x 150 mm x 700 mm made of Cast Iron.
150mm x 150 mm x 750 mm made of Cast Iron.
It consists of a small split cylinder forming a mould on either side of the split cylinder, two parallel indicating arms with pointed ends are attached. Supplied complete with two glass plates and lead weight
Cube Moulds, with base plate : AS PER IS : 516 These are available in different size and are made according to Indian and British Standards. For the metric size cube moulds, the faces are machined flat to /-0.2mm accuracy and finished to within 0.2mm. For the inch size moulds, the faces are machined flat to /-0, 01 inches and finished to within 0.01in.
All moulds are supplied complete with base plate
Cube Moulds, 5cm x 5cm x 5cm
Cube Moulds, 7.06cm x 7.06cm with base plate
Cube Moulds, 10cm x 10cm with base plate
Cube Moulds, 15cm x 15cm with base plate
Ace Engineering & Scientific Equipment (Ace Engineering & Scientific Equipment)
Mahalaxmi Co-op Hsg soc, Shop no: 1, 433, New Mangalwar Peth (Final plot no: 38, somwar peth) next to Ladkat petrol pump, -, Pune, Maharashtra - 411011
Share us via
Write a Review
