My ExportersIndia

For Buyer

For Seller

For Help

AM

Al Muqarram Insulation Material Industry Llc
location Sharjha, United Arab Emirates

Write a Review

Our Products

  1. Sealants 39 Products available
  2. Badges, Emblems & Lanyards 28 Products available
  3. Oil And Lubricants 6 Products available
  4. Silicone Sealants 6 Products available
  5. Adhesives 5 Products available
  6. Paints 5 Products available
  7. Epoxy Coatings 4 Products available
  8. Solvent Cement 4 Products available
  9. Foam Sheets 4 Products available
  10. Solvent Based Adhesives 3 Products available
  11. Air Freshener 3 Products available
  12. Spray Paints 3 Products available
  13. PVC, PP & Plastic Products 2 Products available
  14. Electric Tape 2 Products available
  15. Catalysts And Absorbents 2 Products available
  16. Decorative Tape 2 Products available
  17. Filters & Filtration Systems 2 Products available
  18. Brake Parts 2 Products available
  19. Car Interior Accessories 2 Products available
  20. Automotive Cleaners 2 Products available
  21. Radiators & Radiator Accessories 1 Products available
  22. Acrylic Sealants 1 Products available
  23. Decorative Paints 1 Products available
  24. Floor Cleaner 1 Products available
  25. Paints, Varnishes & Wall Putty 1 Products available
  26. Glass Cleaner 1 Products available
  27. Engine Components 1 Products available
  28. Cleaning Chemicals 1 Products available
  29. Dry Film Lubricants 1 Products available
  30. Fire Extinguisher 1 Products available
  31. Special Purpose Paints 1 Products available
  32. Lubricants 1 Products available
  33. Others Products 16 Products available

Filters & Filtration Systems

Our offered Product range includes Dolphin AQUAFIX Acrylic Membrane and Bituminous Waterproofing.

Dolphin AQUAFIX Acrylic Membrane

DOLPHIN AQUAFIX WATERPROOF is special synthetic resin based waterproof coating. Because of its excellent flexibility and thixotropic nature is an ideal for use on vertical as well as horizontal surfaces.

Application

- Waterproofing for roofs.- Vapor barrier coating for walls and floor.- Waterproofing for roofs ranging from asphalt, asbestos cement, to concrete and terrazzo tiles.- Recommended for both horizontal and inclined Structure.- Can be applied not only to concrete but also to wood and metal surface.- Waterproofing membrane for flat roofing systems (Traditional and Inversed)

Application instruction

WATERPROOFING CONVENTIONAL ROOFS

Asphalt surfaces: Old asphalt surfaces and asphalt roofing felt after cleaning must be primed with DOLPHIN AQUAFIX WATERPROOF diluted with 20% water. This would strengthen the weathered surfaces. Blisters in asphalt roofing felt must be cut open cross wise, dried and bonded with suitable adhesive. After complete drying of the primer and bonded areas, DOLPHIN AQUAFIX WATERPROOF applied with brush, roller or spray gun. A brush with horse hair bristles will provide almost texture-free, smooth surfaces. For spraying, DOLPHIN AQUAFIX WATERPROOF may be diluted with a little water. Higher dilution would lead to sedimentation and blocking0 of spray gun.

Terrazzo Tile Roofs: Damaged or washed-out joints should be cleaned and repaired or re-grouted. After thorough cleaning to remove all loose material, prime the entire surface with 20% diluted DOLPHIN AQUAFIX WATERPROOF. After the primer coat is completely dried, then make two coats of DOLPHIN AQUAFIX WATERPROOF previously described.

Flat roofs with zero pitch: Flat roofs without pitch, so-called zero pitch roofs, are roof surfaces where puddles may develop and which therefore pose special problems. Puddles after curing cannot be rectified which may necessitate redoing the entire waterproofing. Hence dry weather condition is a prerequisite to help satisfactory curing and puddle free coating. Broom with hard bristles (example of stiff plastic) should naturally not be used for cleaning since in unfavorable conditions they may cause damage to the coating.

Metal Roofs: 1st) Iron or galvanized iron: remove loose paint with a wire brush. De-rust corroded areas and prime with suitable metal primers. 2nd) Zinc or aluminum: remove loose paint with a wire brush. Remove corrosion if present and prime with solvent primer. Thoroughly remove moss and mildew with wire brush; subsequently clean the surface with a broom. After thorough drying of the primer, application of DOLPHIN AQUAFIX WATERPROOF carried out as previously mentioned.

Concrete Roofs: After cleaning the roof surfaces, prime with 20% water diluted DOLPHIN AQUAFIX WATERPROOF. After complete drying of the primer, proceed as described under asphalt roof surfaces to apply DOLPHIN AQUAFIX WATERPROOF.

APPLICATION OF MEMBRANEStandard procedures to be followed for cleaning, the substrate and primer coat application. After complete drying of the primer coat, give two coats of DOLPHIN AQUAFIX WATERPROOF at the rate of 0.850 kg. per sq. mtr. making a total of 1.5 to 2 kg. per sq. mtr. including the primer. Curing for 48 hours is adequate at normal temperatures. However at low temperature conditions curing time to be extended accordingly and ensure complete curing before laying thermal insulation and mechanical protection.

THERMAL INSULATION100% closed cellular structured, jointed extruded polystyrene panels are placed over the DOLPHIN AQUAFIX WATERPROOF continuous waterproof membrane. The thickness to be determined by the degree of insulation required.

Storage and Shelf life

Store away from sunlight and preferably below 30C. Storage should be frost protected. DOLPHIN Aquafix Waterproof has 12 months shelf life if stored in required conditions.

View Complete Details

Bituminous Waterproofing

  • Application Building Coating, protective coating
  • Brand Name Dolphin
  • Packaging Details DOLPHIN Bituminous Waterproofing is available in 5 kg bucket, 10 kg bucket and 20 kg bucket.
  • Port Jebel ali
  • Place of Origin United Arab Emirates
View Complete Details
Tell Us What are you looking for? Will call you back

Contact Us