Our Products
Cutter / Shredder / Chipper is operated threw cutting sharp bled .Two rollers uniformly feed long biomass stalk. Adjustable bled cutting material and blow outside. Distance between fix bed and bled is give output size result. It can be adjustable. System is operate threw 25 Hp electric motor or Mobile system can be work to joint at PTO shaft of tractor.
Application :
System Specification :
Electricity / Power :
Production Capacity :Continues feeding is must by manually. Output capacity is depends on the type of Raw Material. For Better production output and lower fuel consumption can be achieved if feeding is regular.
Silent Futures of Radhe Engineering Co. - Cutter / Shredder :
In the Flash Dryer system, Input Biomass (with Higher Moisture) feed in a screw Conveyor mix with hot air. Hot Air which is generated from furnace passes with wet Biomass in duct line. Due to ID Blower developed negative pressure in full system up to duct line.
Moisture liberated from biomass due to more than 100.C Temperature inside system. Due to maximum Contact time and surface area moisture evaporate and separated threw blower discharge. At the bottom of Cyclone dry biomass collected and discharged threw RAV- rotary air lock valve. Moisture (Steam) and flue gases pass to ID fan to Bag house or Chimney.
Application :
Output Capacity of Flash Dryer :
Output Capacity :
If moisture percentage is more then 30% Output prouction capacity will be propotionally less. Output drying capacity is depend on input material moisture %
System Specification :
Technical Specification :
Atomization for Operating :
Land Area & Size ( Approx) :
Silent Futures of Radhe Engineering Co. - Flash dryer :
Hammer Mill is utilized for convert uniform Sizing raw material / Bio-mass. Some agricultural stalk like cotton stalk. Sugarcane leaves, Soybean stalk, wood thin waste, veneer waste are available in big size, so it is not feed able for Briquetting machine.
It's require to cut below 10 mm to 15mm. Hammer mill is the best solution to sizing any kind of Biomass as per required size. Bottom screen can be change as per desired output size. Screw conveyor feed input raw material to Hammering chamber, where nos. of hammer rods are moving and hammering to biomass till convert in screening size Blower and Cyclone is for handling discharge output material.
Application :
Production Capacity of Hammer Mill :
Input Raw material ( Biomass) Specifications :
Output Raw material ( Biomass) Specification :
Production Capacity :Output capacity is depends on the bulk density and type of Raw Material. So it will vary with different type and size of input raw material. If the raw material is bigger like stalk then Shredder / Cutter is required additionally. It will be 1000 Kg to 1500 Kg/Hr
Electricity / Power :
Individual Electric data :
Silent Futures of Radhe Engineering Co. - Hammer Mill :
In Biomass Briquetting plant there are some continues wear and tear parts. Mainly it is a inner layer of die holed and pushing Ram. Due to high mechanical impact after some life it requires to be change. Life of these parts are depend on raw material used that mean silica type harder contain in raw material. If raw material is completely dust free it may long life. Simply life of these parts is depending on raw material quality.
Some auxiliary parts are also required to solution break down. Biomass Briquetting Parts is very imported as concern as quality and applicable alloy material and perfect size.
Wear & Tear Parts (Regular) :
Wear & Tear Parts ( Long Time) :
Auxillary Spares :